GMC · Sonoma

2000 GMC Sonoma Recalls

Small pickup · 4WD/AWD, RWD · Regular

There are 3 safety recalls on file for the 2000 GMC Sonoma, filed between August 1999 and September 2000. Each one is repaired free by a franchised GMC dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 2000 Sonoma is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

2000 (2)

00V258001 Filed Sep 8, 2000 223,194 vehicles

Labels

Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles were built with incorrect payload information on the vehicle certification label. The payload shown on the label is greater than the maximum validated payload. If the vehicle were loaded to the incorrectly labeled payload, it may not ride and handle in the manner that the driver expects.

Risk and remedy
Risk
This could result in a loss of control of the vehicle or an inability to stop the vehicle within expected stopping distances.
Remedy
Owners will be sent a new label for installation on the driver's door of the vehicle.
Filed by
GENERAL MOTORS CORP. (manufacturer number 00063)
00V055000 Filed Feb 28, 2000 10,674 vehicles

Antilock/traction control/electronic limited slip

Vehicle description: light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (ABS) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the ABS would be non-functional.

Risk and remedy
Risk
The base brakes would remain fully functional, but the dynamic rear proportioning (drp) system, which optimizes front to rear brake balance, would become inoperative.
Remedy
Dealers will replace the brake pressure module valve assembly.
Filed by
GENERAL MOTORS CORP. (manufacturer number 00013)

1999 (1)

99V220000 Filed Aug 11, 1999 3,947 vehicles

Antilock/traction control/electronic limited slip

Vehicle description: s -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (ABS) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency, and park braking performance."

Risk and remedy
Risk
If this occurred, the seating seal could be broken during vehicle assembly, or from early road inputs or brake fluid cycling, and a leak could occur increasing the brake stopping distance.
Remedy
Dealers will inspect the brake pipe union for signs of brake fluid, and if necessary, install a new brake pipe union.
Filed by
GENERAL MOTORS CORP. (manufacturer number 99049)

Recall questions

How many recalls does the 2000 GMC Sonoma have?

NHTSA lists 3 recalls for the 2000 GMC Sonoma.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.