Owners of the 2015 GMC Yukon have reported 34 engine problems to NHTSA, 6% of all complaints about this model year.
The typical report came at around 67,000 miles, and complaints were filed between April 2015 and September 2026.
These engine complaints include 1 fire.
For comparison, the 2021 Yukon has the most engine complaints of any year, with 219.
Engine and cooling: stalling, loss of power, oil consumption, overheating, knocking, failed internal parts and check-engine faults traced to the engine.
1 recall for this model year involves the engine.
If your problem matches, a dealer repairs it free under the recall.
Complaints34
Typical mileage67k
Crashes / fires0 / 1
Injuries0
What owners say
EngineFiled Sep 2026WA
The vehicle developed a recurring cylinder #4 misfire with a flashing check-engine light, rough running, and reduced performance. Diagnostic code P0304 repeatedly returned. Replacing the #4 spark plug temporarily restored normal operation, but the misfire returned after a few hundred miles. The #4 plug was wet/oily, and fresh oil was found pooled in the #4 intake port while the other ports were dry. All eight spark plugs, ignition coils, and plug wires were replaced, along with the #4 fuel injector and both #4 valve-stem seals, but the misfire persisted. A valvetrain/lifter tick later became audible near 3,000 RPM.
Owner complaint 11766089 filed with NHTSA
EngineFiled May 2026OR
While traveling at highway speeds on Interstate 5 in Oregon, my 2015 GMC Yukon Denali experienced a sudden, catastrophic engine failure with zero advance warning. The vehicle instantly lost almost all propulsion and power while surrounded by high-speed traffic, creating an immediate and severe safety hazard on a major interstate. The engine began making a loud, severe knocking noise, and I was forced to navigate across lanes without adequate power to reach the shoulder. The vehicle was towed and inspected by Point S in Creswell, OR, where diagnostics confirmed a P0300 random/multiple cylinder misfire, with cylinder 4 specifically misfiring.
Owner complaint 11739721 filed with NHTSA
EngineFiled Feb 2026WI
Noticed a tick sound. Sent to dealer. Lifter failed. Bent push rod. Took it in Nov 24th. Charged $7,100. Fixed all lifters and bent push rod. Was turning around in my driveway and vehicle just shut off. Took it back to same dealer in Jan 27th. Bad lifter. Same push rod. Still in shop. Thatâs two months and 2,000 miles and had same failure. That is absolutely ridiculous GM and I should be compensated for this. It has costed me $7100 dollars. They are fixing with a two year warranty but if the failures are so close together, whoâs to say it wonât just keep happening. Not only is it a safety issue, it is hurting my finances.
General Motors is recalling certain 2014 model year Chevrolet Silverado 1500 and GMC Sierra 1500 vehicles, and 2015 model year Cadillac Escalade and Escalade ESV; Chevrolet Silverado HD; and GMC Sierra HD, Yukon, and Yukon XL, equipped with a 4.3L engine or 5.3L engine.
Risk and remedy
Risk
The overheated exhaust components may melt nearby plastic parts and may result in an engine fire.
Remedy
General Motors will notify owners, and dealers will reprogram the engine control module, free of charge. The recall began on January 16, 2014. Owners may contact Chevrolet at 1-800-222-1020 and GMC at 1-800-462-8782. General Motors' number for this recall is 14008.