Owners of the 1991 Honda Accord have reported 58 seat belt problems to NHTSA, 27% of all complaints about this model year.
Where owners named a specific part, the most common were front (24) and rear/other (1).
The typical report came at around 188,000 miles, and complaints were filed between February 1995 and August 2018.
These seat belt complaints include 10 crashes and 10 injuries.
No other Accord year has as many seat belt complaints.
Belts, buckles, retractors, pretensioners and anchorages.
2 recalls for this model year involve the seat belt.
If your problem matches, a dealer repairs it free under the recall.
Complaints58
Typical mileage188k
Crashes / fires10 / 0
Injuries10
Parts named in these complaints
Front24
Rear/Other1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Seat beltsFiled Aug 2018213,869 milesCA
The automatic seat belt on my driver side is stuck in the forward position. The passenger side belt works just fine, just not the driver side. This happened after I had my distributor replaced and when I started my car up, it wouldn't work.
Owner complaint 11120596 filed with NHTSA
Seat beltsFiled Jun 2016PA
The driver side automatic retractable seat belt restraint is currently stuck in the forward position by the window and will not retract. We have taken the car for a diagnostic check to verify that it needs replaced. The part is supposed to be covered under the lifetime seatbelt warranty but we are having continued issues getting something done. They have told US they CAN't locate a part, that they aren't "sure" if it's covered, and have basically brushed US off.
Owner complaint 10873862 filed with NHTSA
Seat beltsFiled May 2016229,000 milesPA
Tl* the contact owns a 1991 Honda Accord. The contact stated that the driver side seat belt failed to retract and expand. The contact took the vehicle to the dealer where it was diagnosed that the shoulder restraint failed and the seat belt retractor needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure and opened a case on the contact's behalf. The approximate failure mileage was 229,000.
The front safety belt buckle release buttons CAN break. These red plastic release buttons are marked "press." if a button breaks, pieces CAN fall into the buckle assembly causing the buckle to operate improperly.
Risk and remedy
Risk
The safety belts would not provide adequate protection to an occupant in a vehicle crash.
Remedy
Owners should promptly check the condition and operation of both front safety belt buckles. Carefully inspect the red release button for any breaks or cracks. Check that both buckles are operating properly by inserting each latch plate into its buckle, tug on the belt to make sure the latch is securely locked, then press the release button. The latch plate should pop out of the buckle when the button is pressed. If either release button shows any sign of breakage or cracking, or if either buckle fails to operate properly, promptly contact your authorized honda/acura dealer to schedule an appointment to have the buckle replaced or repaired, free of charge. The manufacturer is developing a remedy designed to prevent the failure of the buttons that are not currently broken.
The rear outside seating position safety belts may lock up AT angles other than those required by fmvss 209, "seat belt assemblies". This does not conform to the motor vehicle safety standard.
Risk and remedy
Risk
Non-conforming safety belts cause an increased risk of injury in the event of a sudden stop or accident.
Remedy
Replace the sensor in the rear seat belt retractor.