Owners of the 2003 Infiniti M45 have reported 40 engine problems to NHTSA, 31% of all complaints about this model year.
Where owners named a specific part, the most common were engine (5) and exhaust system (1).
The typical report came at around 122,000 miles, and complaints were filed between May 2004 and July 2019.
No other M45 year has as many engine complaints.
Engine and cooling: stalling, loss of power, oil consumption, overheating, knocking, failed internal parts and check-engine faults traced to the engine.
1 recall for this model year involves the engine.
If your problem matches, a dealer repairs it free under the recall.
Complaints40
Typical mileage122k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Engine5
Exhaust System1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
EngineFiled Jul 2019106,000 milesAR
2003 Infiniti M45 with approximately 106,000 miles. Car will stall suddenly AT highway or city road speeds necessitating putting car into neutral or pulling over to restart. Previously, after this had happened, a code for faulty crankshaft position sensor was recovered, and both the crankshaft and camshaft position sensors were replaced with aftermarket new parts from duralast. Car no longer has a check engine light code associated with the stalling, but the stalling persists.
Owner complaint 11235295 filed with NHTSA
EngineFiled Aug 2018100,000 milesNV
Tl* the contact owns a 2003 Infiniti M45. While stationary and while driving various speeds,the vehicle stalled without warning on several occasions. The contact stated that there was a complete loss of power. The contact coasted the vehicle to the side of the road and was able to restart the vehicle. On another occasion, the contact stated that the engine indicator illuminated and "check your fuel cap" displayed on the instrument panel. A dealer and the manufacturer were not made aware of the failures.
Owner complaint 11121152 filed with NHTSA
EngineFiled May 2017145,000 milesTX
Tl* the contact owns a 2003 Infiniti M45. While driving the vehicle, the check engine indicator illuminated and the vehicle stalled. The vehicle was taken to the dealer, but was not diagnosed or repaired. The vehicle was taken to an independent mechanic who diagnosed that the crankshaft sensor needed to be replaced. The vehicle was repaired, but the failure persisted. The manufacturer was made aware of the failure. The failure mileage was 145,000.
On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
Risk and remedy
Risk
This could cause the "service engine soon" warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.
Remedy
Dealers will replace the crank position sensors. Camshaft position sensor(s), and in some cases, the variable timing control sensor(s). Vehicles involved in a previous recall campaign, 01v357, are also included in this new campaign. The replacement sensors used in that campaign are also affected. Owner notification began on december 22, 2003. Owners should contact nissan AT 1-800-647-7261 or infiniti AT 1-800-662-6200.
Filed by
NISSAN NORTH AMERICA, INC. (manufacturer number R3021/R3022)