Owners of the 2015 Infiniti Q50 have reported 39 transmission problems to NHTSA, 31% of all complaints about this model year.
Where owners named a specific part, the most common were automatic transmission (1).
The typical report came at around 80,000 miles, and complaints were filed between September 2020 and August 2026.
These transmission complaints include 1 fire.
No other Q50 year has as many transmission complaints.
Automatic and manual transmissions, CVTs, clutches, axles, driveshafts and transfer cases: harsh or delayed shifts, slipping, shuddering and rolling away in park.
1 recall for this model year involves the transmission.
If your problem matches, a dealer repairs it free under the recall.
Complaints39
Typical mileage80k
Crashes / fires0 / 1
Injuries0
Parts named in these complaints
Automatic Transmission1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Transmission and drivetrainFiled Aug 2026VA
While operating the vehicle, the transmission suffered an abrupt failure resulting in Diagnostic Trouble Code (DTC) P0720 (Output Speed Sensor Circuit). Further diagnostic inspection revealed a complete internal failure of the integrated valve body assembly, which houses the Transmission Control Module (TCM), solenoids, and output speed sensors. The failure caused an immediate loss of gear selection, restricting the transmission to 3rd gear ("limp mode").
Owner complaint 11756528 filed with NHTSA
Transmission and drivetrainFiled Jul 2026AL
While driving my 2015 Infiniti Q50s, the transmission suddenly suffered a catastrophic electronic failure, causing the vehicle to immediately drop into "limp mode." This resulted in a sudden and dangerous loss of acceleration while operating in traffic. A diagnostic scan revealed trouble codes P0500 and P0720 (Output Speed Sensor circuit). However, following Infiniti's official Technical Service Bulletin (TSB ITB19-040), the actual failure was the Transmission Control Module (TCM), which is permanently integrated into the transmission control valve body inside the transmission.
Owner complaint 11750490 filed with NHTSA
Transmission and drivetrainFiled May 2026MD
The valve body on these cars are useless. Driving down a highway and cant shift out of 3rd gear almost had a car re-end me. Today I am driving and the ECU is not responding I see the check engine light on then I'm like not again. This would be the 3rd valve body I replaced. First I replaced the whole transmission thinking that is what I needed and advised that the valve body and the transmission are one. Yet no they come in parts. Anyways today I am waiting to get home, but the car is not reading my key fob why? Then the ECU and code U0100 is popping up. Something new and turns the car off.
Nissan North America, Inc. (INFINITI) is recalling certain 2011-2013 M56, 2012-2013 M35 Hybrid, 2014-2018 Q50, Q70 Hybrid, 2014-2019 Q70, and 2015-2019 Q70L two-wheel drive vehicles. The driveshaft can fatigue and break.
Risk and remedy
Risk
A broken driveshaft can result in a loss of drive power, or a vehicle roll away when the vehicle is in park without the parking brake applied. Both scenarios can increase the risk of a crash.
Remedy
Dealers will replace the driveshaft, free of charge. Owner notification letters were mailed August 13, 2024. Owners may contact INFINITI's customer service at 1-800-662-6200. INFINITI's numbers for this recall are R24A5 and R24A7.
Filed by
Nissan North America, Inc. (manufacturer number R24A5, R24A7)
Transmission and drivetrain complaints across Q50 years