There are 5 safety recalls on file for the 1998 Isuzu Amigo,
filed between May 1998 and June 2012.
Each one is repaired free by a franchised Isuzu dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1998 Amigo is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2012 (1)
Isuzu is recalling certain model year 1998-2000 amigo and model year 2001-2002 rodeo sport vehicles, that were originally sold, or are currently registered, in the states of maine, new hampshire, vermont, massachusetts, rhode island, connecticut, new york, new jersey, pennsylvania, delaware, maryland, the district of columbia, west virginia, ohio, indiana, michigan, illinois, wisconsin, minnesota, iowa, missouri, and kentucky. These vehicles may experience excessive corrosion in the vicinity of the forward mounting point bracket for the left or right rear suspension lower link.
Risk and remedy
- Risk
- Excessive corrosion may result in the left or right rear suspension lower link bracket becoming detached from the frame, which CAN affect vehicle handling and increase the risk of a crash.
- Remedy
- Dealers will inspect the rear suspension lower link bracket area. For vehicles in which little or no corrosion is found, the area will be treated with an anti-corrosive compound. For vehicles in which corrosion has damaged the rear suspension lower link bracket and affected its connection to the vehicle frame, a reinforcement bracket will be installed. In the rare event the corrosion is so severe that the reinforcement bracket remedy would not be appropriate, isuzu will offer to repurchase the vehicle for an amount based on the kelley blue book âprivate partyâ price. All inspections and remedies will be provided free of charge for vehicles that are 10 years old or less. For vehicles older than 10 years, isuzu will offer a free remedy, but only if the vehicle is presented to an isuzu service facility dealer within 12 months of when owner notifications were issued. The recall began during july 2012. Isuzu owners may contact isuzu AT 1-800-255-6727.
- Filed by
- ISUZU MANUFACTURING SERVICES OF AMERICA
2000 (1)
Vehicle description: sport utility vehicles. Paint was applied unevenly on the rear axles, resulting in insufficient paint hardness. Should this occur on the surface that contacts the rear axle lower link bracket bolt head and/or nut, the nut may loosen.
Risk and remedy
- Risk
- The bolt could detach fully, causing separation of the lower link from the rear axle, increasing the risk of loss of vehicle control.
- Remedy
- Dealers will replace the rear axle lower link joint nut and bolt.
- Filed by
- ISUZU MOTORS LIMITED
1998 (3)
Vehicle description: passenger vehicles equipped with a sunroof sunshade. The primer applied to prepare the surface prior to bonding the sunshade holders to the sunroof weakened the bonding strength of the adhesive, resulting in an unsatisfactory bond of the holder to the sunroof.
Risk and remedy
- Risk
- This condition CAN result in separation of the holder, causing the sunshade to fall, possibly striking a vehicle occupant.
- Remedy
- Dealers will remove all four sunshade holders and re-bond them to the sunroof glass.
- Filed by
- ISUZU MOTORS LIMITED
Vehicle description: sport utility vehicles. A ground connection terminal was not properly crimped in the supplier's engine wiring harness manufacturing line. This improper crimping process CAN leave an impression on the terminal that will eventually cause a stress fracture. S
Risk and remedy
- Risk
- If a terminal is fractured, the powertrain control module (PCM) CAN receive an erroneous signal indicating a high vehicle speed, thereby causing the PCM to cut the fuel, causing a 'no-start' condition, or a possible engine stall.
- Remedy
- Dealers will replace the wiring harness on these vehicles.
- Filed by
- ISUZU MOTORS LIMITED
Vehicle description: sport utility vehicles. The strength of the rear seat belt shoulder anchorage is not to design specifications and does not fully comply with requirements of fmvss no. 210, "seat belt assembly anchorages."
Risk and remedy
- Risk
- The rear seat belts would not provide adequate protection in the event of a vehicle crash.
- Remedy
- Dealers will install new right and left rear seat belt anchor bolts.
- Filed by
- ISUZU MOTORS LIMITED
Recall questions
How many recalls does the 1998 Isuzu Amigo have?
NHTSA lists 5 recalls for the 1998 Isuzu Amigo.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.