There are 5 safety recalls on file for the 1994 Jeep Cherokee,
filed between September 1993 and May 2011.
Each one is repaired free by a franchised Jeep dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1994 Cherokee is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2011 (1)
U.s. Drive right is recalling certain model year 1994-1996 jeep cherokee vehicles imported from january 2007, through april 2011 for failing to comply with federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment," for the high mount brake lamp assembly. The vehicles are not equipped with the required third brake lamp.
Risk and remedy
- Risk
- Inadequate lighting could reduce visibility of vehicle, increasing the risk of a crash.
- Remedy
- U.s. Drive right will notify owners and mail kits along with instructions to have the vehicle repaired by a qualified mechanic of their choice, free of charge. The safety recall began on september 12, 2011. Owners may contact u.s. Drive right AT 1-888-632-5936.
- Filed by
- U.S. DRIVE RIGHT
2008 (1)
U.s. Drive right is recalling 107 my 1994-1998 right hand drive, 4-wheel drive jeep cherokee vehicles. These vehicles fail to comply with the requirements of fmvss no. 101, 'controls and displays;' no. 108, 'lamps, reflective devices and associated equipment;' no. 111, 'rearview mirror;' no. 114, 'theft protection;' no. 115, 'vehicle identification number;' no. 118, 'power window system;' no. 120, 'tire selection and rims for motor vehicles other than passenger cars;' no. 208, 'occupant crash protection;' and no. 301, 'fuel system integrity.'
Risk and remedy
- Risk
- These vehicles do not meet the required standards.
- Remedy
- U.s. Drive right will make all the required modifications. A representative will travel to the customer's location and make the modifications on site. The recall will be performed on a regional basis beginning march 2008. Owners may contact u.s. Drive right AT 1-888-632-5936.
- Filed by
- U.S. DRIVE RIGHT
1999 (1)
99V340000
Filed Dec 13, 1999 334,047 vehicles
Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors CAN experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion CAN eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
Risk and remedy
- Risk
- The reduced strength CAN allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
- Remedy
- Dealers will replace these rotors with rotors that are coated with a corrosion protection.
- Filed by
- DAIMLERCHRYSLER CORPORATION
1997 (1)
During assembly of the frame, a fillet weld that joins the inner steering gear attachment reinforcement to the frame rail, was omitted.
Risk and remedy
- Risk
- Due to high steering load events, vehicles CAN exhibit broken steering gear attaching bolts or frame rail cracking AT the steering gear attaching point increasing the risk of a vehicle crash.
- Remedy
- Dealers will inspect the vehicles for cracks in the frame rail. Vehicles that show cracks will be equipped with reinforcement plates. Vehicles that are found to be free of cracks will have a slot cut in the cross member and the fillet weld will be added.
- Filed by
- CHRYSLER CORPORATION
1993 (1)
The two rear inboard safety belt attachment bolts may have inadequate thread engagement into the floor pan anchor nuts.
Risk and remedy
- Risk
- The safety belt attachment bolts may not support theload of rear seat passengers in the event of a sudden stop or accident; theassembly fails to comply with the static load requirements of fmvss 210, "seatbelt assembly anchorages." the inability to support the load of rear seatpassengers increases the risk of injury to seat occupants.
- Remedy
- Replace the two inboard safety belt anchor bolts with longer bolts on all vehicles.
- Filed by
- CHRYSLER CORPORATION
Recall questions
How many recalls does the 1994 Jeep Cherokee have?
NHTSA lists 5 recalls for the 1994 Jeep Cherokee.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.