2010 Jeep Commander Problems
SUV · 4WD, RWD · Regular
Owners have filed 45 complaints about the 2010 Jeep Commander with NHTSA's vehicle safety hotline and website. The electrical system leads with 18, then the engine with 16. Reports for this year mention 3 fires.
One complaint can name more than one system, so the groups below add up to more than the total. Open a group for the parts owners name, the mileage and their own words.
- Electrical system 40% of complaints · median 70,000 miles · Ignition 18
- Engine 36% of complaints · median 62,000 miles 16
- Brakes 11% of complaints · median 75,000 miles 5
- Transmission and drivetrain 11% of complaints · median 75,000 miles 5
- Steering 9% of complaints · median 85,000 miles 4
- Speed control 9% of complaints · median 69,000 miles 4
- Body and structure 4% of complaints · Body 2
- Lights 4% of complaints · median 48,000 miles 2
- Wheels 4% of complaints · median 84,000 miles 2
- Seat belts 4% of complaints · median 45,000 miles 2
- Suspension 4% of complaints · median 85,000 miles 2
- Fuel system 4% of complaints · median 38,000 miles 2
- Stability and traction control 4% of complaints · median 73,000 miles 2
- Other or unknown 2% of complaints · median 22,000 miles 1
- Seats 2% of complaints 1
- Tires 2% of complaints 1
Latest owner reports
Started the vehicle by inserting the key fob. Turned the key and the vehicle dash lit up and went out immediately. Tried to turn the key again and nothing happened. Could not turn the key and it was difficult to remove the key fob from the ignition.
The engine failed while driving at major intersection. Multiple individuals had to assist and avoid causing an accident. After a week at diagnostic Jeep service department, techs determined compression failure in cylinders 2 and 4 with 0 psi. There no codes or check engine lights other than a brief blinking right before failure.
The electrical system of my car malfunctioned intermittently causing lights, ac, and the engine itself to go off and on in the middle of the freeway. There was a recall on the 2010 Jeep Commander (same as my car) for faulty electrical system, yet my VIN was excluded. I believe it should have been included in the recall and this faulty electrical system was the cause of multiple repairs done at my expense to the tune of a couple thousand dollars. I ask for a query into this. The electrical system is the nexus of a carâs mechanical system and if not functioning correctly causes all else to eventually fail.
Engine stalled at stop signs, Daughter was driving the vehicle and engine stalled at an intersection. Not able to restart it. Vehicle was pushed to the side. I went to assist her and after many tries the engine restarted, I started to drive and the engine will stall as n DC shutdown at all stop signs/ traffic lights. I managed to drive it to the Jeep dealer shifting into neutral and pressing the gas to keep the engine running. No engine lights were present, temperature was normal and vehicle had 1/4 tank of gas. After a 5 days in the the dealer, they indicated that there is nothing wrong with the vehicle, no codes.