There are 6 safety recalls on file for the 1993 Jeep Grand Wagoneer,
filed between December 1992 and February 2002.
Each one is repaired free by a franchised Jeep dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1993 Grand Wagoneer is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2002 (1)
02V053000
Filed Feb 15, 2002 1,620,000 vehicles
On certain sport utility vehicles, if a driver has not placed the shifter lever fully into the "park" position and leaves the vehicle running, the vehicle may unexpectedly move rearward after seeming to be stable.
Risk and remedy
- Risk
- Inadvertent movement of the vehicle could result in a crash.
- Remedy
- Dealers will install a secondary detent system to the floor shifter assembly. Daimlerchrysler sent interim notices to owners concerning this problem on march 22, 2002. Owner notification began september 23, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler AT 1-800-853-1403.
- Filed by
- DAIMLERCHRYSLER CORPORATION (manufacturer number B02)
1999 (1)
99V340000
Filed Dec 13, 1999 334,047 vehicles
Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors CAN experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion CAN eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
Risk and remedy
- Risk
- The reduced strength CAN allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
- Remedy
- Dealers will replace these rotors with rotors that are coated with a corrosion protection.
- Filed by
- DAIMLERCHRYSLER CORPORATION
1993 (3)
93V210000
Filed Dec 13, 1993 115,000 vehicles
The molded plastic pin which connects the upper steering column shaft and the lower column shaft may have been sheared prior to installation of the steering column assembly into the vehicle. If this occurred, the upper steering shaft will separate from the lower steering shaft.
Risk and remedy
- Risk
- If the upper and lower steering shafts separate, completeloss of steering control will occur, which could result in an accident.
- Remedy
- A restraining sleeve will be added to the intermediate shaft to limit the amount of steering shaft movement available.
- Filed by
- CHRYSLER CORPORATION
Grease applied to the liftgate latch rubber bumpers to ease component assembly caused the bumper to swell, interfering with the movement of the liftgate latch pawl. This prevents the liftgate latching when closed and difficult to open when latched.
Risk and remedy
- Risk
- An unlatched liftgate CAN open while the vehicle is inmotion, and could result in an occupant falling out.
- Remedy
- Replace the liftgate assembly on affected vehicles.
- Filed by
- CHRYSLER CORPORATION
The eccentric cam adjuster bolts in both front lower suspension arm-to-front axle bracket attachments may fail due to assembly misalignment.
Risk and remedy
- Risk
- Cam bolt failures cause the vehicle to pull to oneside when the brakes are applied, resulting in a possible loss of vehiclecontrol and an accident.
- Remedy
- Replace the front suspension cam bolts, cam washers, and nuts with components of a different design.
- Filed by
- CHRYSLER CORPORATION
1992 (1)
The retainer clip which secures the master cylinder input rod to the brake pedal was not installed properly, and could work loose.
Risk and remedy
- Risk
- Disengagement of the retainer clip will allow free playin the attachment and CAN allow the input rod to separate from the brake pedalcausing complete loss of brake application which could result in an accident.
- Remedy
- Improperly installed retainer clips will be removed and new retainer clips will be properly installed.
- Filed by
- CHRYSLER CORPORATION
Recall questions
How many recalls does the 1993 Jeep Grand Wagoneer have?
NHTSA lists 6 recalls for the 1993 Jeep Grand Wagoneer.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.