Owners of the 1990 Jeep Wagoneer have reported 8 brakes problems to NHTSA, 62% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (7), foundation components (2), and antilock (2).
The typical report came at around 109,000 miles, and complaints were filed between October 1995 and May 2004.
For comparison, the 2022 Wagoneer has the most brakes complaints of any year, with 39.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
4 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled May 2004109,435 milesFL
Continued anti-lock and brake failure with no warning. System replaced on 2/11/97, 11/10/00, 11/16/00, & 2/13/01. Replaced with same parts that continue to fail. Very dangerous. Brakes go to floor with no warning. Request for service in 11/03 after failure did not find problem. System has failed 4 times since then. Dealer currently has vehicle.
Owner complaint 10073075 filed with NHTSA
BrakesFiled Dec 1996VA
When applying the ABS brakes, the brake pedal went to the floor and brakes failed to stop the vehicle, had to replace brake pump and accumulator. *ak there is a recall regarding this, 96v260, consumer paid $1543 for repairs.
Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors CAN experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion CAN eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
Risk and remedy
Risk
The reduced strength CAN allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
Remedy
Dealers will replace these rotors with rotors that are coated with a corrosion protection.
Vehicle description: vehicles equipped with antilock brake system (ABS). The antilock brake system (ABS) hydraulic control unit CAN experience excessive brake actuator piston seal wear which could cause pump-motor deterioration.
Risk and remedy
Risk
If this occurs, the ABS function would be lose and reduced power assist would be experienced during vehicle braking. The instrument panel warning lights will signal system impairment and the base manual brakes will remain functional.
Remedy
Dealers will test the vehicle's ABS and repair as necessary. The warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will be reimbursed for previous ABS component repair costs.
There may be hydraulic fluid contamination from condensation formation that CAN plug the ABS brake booster pump filter; stress corrosion of the master cylinder snap ring has been traced to chlorine leaking from the low pressure hydraulic hose which may cause it to break; front brake hose to tire interference which may cause failure of the brake hose.
Risk and remedy
Risk
Contamination of the hydraulic fluid CAN causemalfunctioning of the anti-lock brake system; low pressure hose leakage causesloss of brake fluid and also results in corrosion and failure of the mastercylinder snap ring, resulting complete brake failure; failure of the front brakehose due to hose to tire interference will cause failure of one half of thebrake system resulting in a longer stopping distance than expected.
Remedy
Replace ABS low pressure hose; rebuild master brake cylinder; inspect, service interference problems, and replace front brake hose as necessary.
Improper insertion/crimping of the hose-to-end fittings of the high pressure hose on the anti-lock brake system CAN cause detachment of the hose from the ABS system, and discharge of hydraulic fluid.
Risk and remedy
Risk
Detachment of the hose from the ABS system causes theloss of the ABS function and hydraulic brake assist, leaving only manual brakesand decreasing stopping ability, which could result in an accident. Discharge ofhydraulic fluid in the area of the hot exhaust system could result in an enginecompartment fire.