Owners of the 1999 Mazda 626 have reported 16 brakes problems to NHTSA, 5% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (10), antilock/traction control/electronic limited slip (3), and power assist (1).
The typical report came at around 78,000 miles, and complaints were filed between September 1999 and November 2015.
These brakes complaints include 5 crashes and 1 injury.
For comparison, the 1993 626 has the most brakes complaints of any year, with 25.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Jan 2008145,000 milesNCCrash
Tl*the contact owns a 1999 Mazda 626. While driving 55 MPH downhill, the contact stated that she lost control of the steering when she depressed the brake pedal then crashed into a tree. As a result, the crash destroyed the vehicle. The road conditions were wet. The rear passenger sustained a broken left leg while seated in a child seat. There is a recall for service brakes, hydraulic: foundation components: master cylinder (NHTSA campaign ID #00v074000) however, the manufacturer stated that her VIN was not included. As of January 2, 2008, the dealer had not inspected the vehicle. The current and failure mileages were 145,000.
Owner complaint 10213388 filed with NHTSA
BrakesFiled Dec 2005FL
Dt: the contact states there are three NHTSA recalls, campaigns 00v074000 regarding the service brakes: master cylinder, 00v134000 regarding engine and engine coolant: engine, and 05e065000 regarding the fuel system. The vehicle has the same problems as indicated in the recall; however, it is not included in the recall due to the VIN.
Vehicle description: passenger vehicles. Certain reservoir tank caps on the brake master cylinder were produced with a worn out die and lack ventilation holes. As a result, the pressure in the reservoir tank CAN drop gradually as the brake pad or shoe wears and ambient temperature drops. Also, the pressure could reach a point that the brake caliper and drum cylinder are pulled back by the vacuum in the reservoir tank when the vehicle is parked for a long time.
Risk and remedy
Risk
This condition could cause reduced brake efficiency, increasing the risk of a crash.
Remedy
Dealers will inspect the reservoir cap and replace it, if necessary.
Filed by
MAZDA NORTH AMERICAN OPERATIONS (manufacturer number 89004)