2002 Mazda B-Series Truck Problems
Model year 2002
Owners have filed 28 complaints about the 2002 Mazda B-Series Truck with NHTSA's vehicle safety hotline and website. The engine leads with 6, then the air bags with 6. Reports for this year mention 5 crashes and 6 injuries.
One complaint can name more than one system, so the groups below add up to more than the total. Open a group for the parts owners name, the mileage and their own words.
- Engine 21% of complaints · median 26,000 miles · Engine 6
- Air bags 21% of complaints · median 22,000 miles · Frontal 6
- Transmission and drivetrain 21% of complaints · median 22,000 miles · Manual Transmission 6
- Speed control 11% of complaints · median 41,000 miles · Cruise Control 3
- Seats 7% of complaints · median 48,000 miles · Front Assembly 2
- Tires 7% of complaints · Sidewall 2
- Brakes 7% of complaints · median 25,000 miles · Antilock/Traction Control/Electronic Limited Slip 2
- Seat belts 7% of complaints · median 51,000 miles · Front 2
- Lights 4% of complaints · median 73,000 miles · Headlights 1
- Stability and traction control 4% of complaints 1
Latest owner reports
Transmission 1st/2nd gear synchromesh went out 5 times, finally Mazda admitted something was wrong with engine,3x was under warranty, last 2x I paid all costs. Judge ruled against Mazda in small claims court.
Transmission 1st/2nd gear synchromesh went out 5 times, finally Mazda admitted something was wrong with engine,3x was under warranty, last 2x I paid all costs. Judge ruled against Mazda in small claims court.
Engine cooling system had internal corrosion which caused heating failure (thermostat). In new hampshire when the temperature is AT or below zero, the risk of freezing to death because the car will not heat properly could have its consequences. In order to correct the problem, the engine had to be replaced (used engine) AT a cost of $3000.00 the problem was caused, most likely by incorrect antifreeze installed in the engine. This was done either AT the factory or the new car dealership when the car was preped for sale.
Since I purchased the vehicle there has been noticeable play in the rear differential. I ignored it for a long time and then after the warranty had expired I took it to a repair shop in the area that has a very good reputation for repairing and setting up differentials. After examining the gears in the rear end he told me the play was caused by a part that was machined incorrectly AT the factory. He said it was a hole that was drilled too large for the pin that is installed in it to hold the axle gears in place. He assured me that it was not caused by wear because this pin is not a moving part.