Mazda · Navajo

1993 Mazda Navajo Recalls

Special purpose vehicle · RWD · Regular

There are 5 safety recalls on file for the 1993 Mazda Navajo, filed between October 1994 and November 1999. Each one is repaired free by a franchised Mazda dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1993 Navajo is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1999 (1)

99V310002 Filed Nov 24, 1999 6,800 vehicles

Support device/strut

Vehicle description: on certain sport utility vehicles, the hydraulic lift cylinder bracket welds could fracture.

Risk and remedy
Risk
With a broken bracket weld, there is a potential for the liftgate bracket to gradually bend inward allowing the lift cylinder ball stud to disengage, unexpectedly allowing the liftgate to fall from an open position.
Remedy
Dealers will install liftgate reinforcement brackets. Depending upon the condition of the liftgate sheet metal in the area of the bracket, dealers may also install a larger reinforcement.
Filed by
MAZDA (NORTH AMERICA),INC

1998 (1)

97V235002 Filed Feb 25, 1998 23,000 vehicles

Roof and pillars

Vehicle description: multi-purpose passenger vehicles equipped with factory installed sunroof. The sunroof glass panel assembly CAN separate while the vehicle is moving due to incorrect hinge engagement. This was caused by improper sunroof installation of the glass panel.

Risk and remedy
Risk
Unexpected separation of the sunroof glass panel could possibly distract the driver increasing the risk of a vehicle crash or loss of vehicle control.
Remedy
Owners will be provided with an instruction booklet which thoroughly outlines, with illustrations, the proper procedures for the removal, storage, and reinstallation of the sunroof's glass panel. A warning label for attachment to the sunroof's latch knob will also be provided to the owners.
Filed by
MAZDA (NORTH AMERICA),INC

1996 (1)

96V024002 Filed Feb 28, 1996 2,500 vehicles

Hydraulic

The studs which attach the brake master cylinder to the power brake vacuum booster assembly CAN develop stress corrosion cracking after being operated for an extended period of time in the southern california location.

Risk and remedy
Risk
If a crack occurs, it could result in one or both studs fracturing. The master cylinder could then separate from the vacuum booster, when the brakes are applied, preventing the service brakes from fully activating increasing the risk of a vehicle accident.
Remedy
Dealers will replace the power brake vacuum booster assembly.
Filed by
MAZDA (NORTH AMERICA),INC

1995 (1)

95V164002 Filed Aug 28, 1995 6,973 vehicles

Support device/strut

The hydraulic lift cylinders are attached to brackets that are welded to the liftgate. The bracket welds CAN fracture.

Risk and remedy
Risk
With a broken bracket weld, there is a potential for the liftgate bracket to gradually bend inward allowing the lift cylinder ballstud to disengage.
Remedy
Dealers will install reinforcement brackets.
Filed by
MAZDA (NORTH AMERICA),INC

1994 (1)

94V169002 Filed Oct 31, 1994 48,609 vehicles

Conventional

The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.

Risk and remedy
Risk
When the above occurs, it CAN result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
Remedy
A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.
Filed by
MAZDA (NORTH AMERICA),INC

Recall questions

How many recalls does the 1993 Mazda Navajo have?

NHTSA lists 5 recalls for the 1993 Mazda Navajo.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.