Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Sep 2023NY
My ABS keeps locking up and Ive almost wrecked multiple times. I changed brakes and rotors and still the problem is on-going. Its dangerous and Ive read others saying the same thing online.
Owner complaint 11542450 filed with NHTSA
BrakesFiled Aug 2019NY
The ABS malfunctioned and the ABS light is on. When I engage the break it makes noise initial before it will start to engage properly, but the ABS light keeps showing steadily. The trunk of the vehicle remains locked and cannot open. The latch is not bad.
Owner complaint 11245355 filed with NHTSA
BrakesFiled Sep 201758,899 milesNY
Tl* the contact's son owns a 2003 Mazda Tribute. While the contact's son was driving AT an unknown speed, the ABS indicator illuminated. While the brake pedal was depressed, the vehicle failed to come to a complete stop. The vehicle was taken to island Mazda (1580 hylan blvd, staten island, ny 10305 (844) 667-0618) where it was diagnosed that the ABS module's electrical wiring harness needed to be replaced. The vehicle was not repaired. The contact referenced NHTSA campaign number: 07v157000 (service brakes, hydraulic), but the dealer stated that the recall was closed on February 8, 2008.
On certain sport utility vehicles equipped with antilock brakes (ABS), the ABS module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.
Risk and remedy
Risk
An electrical short might cause an ABS malfunction that would illuminate the ABS warning light, and in some cases, the module may overheat resulting in burning odor, smoke, and/or fire. This condition could occur either when the vehicle ignition switch is in the off position or while the vehicle is being operated.
Remedy
Dealers will inspect the wire harness connector to the ABS module for missing or dislodged wire seals, and repair or replace the harness connector as appropriate. The dealer will also inspect the connector on the ABS module and replace it if it is found to be corroded or damaged. The recall began on may 9, 2007. Owners may contact mazda AT 1-800-222-5500.