Owners of the 1994 Mercury Grand Marquis have reported 19 brakes problems to NHTSA, 12% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (13), antilock/traction control/electronic limited slip (9), and brake fluid low warning (1).
The typical report came at around 99,000 miles, and complaints were filed between March 1995 and September 2009.
These brakes complaints include 3 crashes, 1 fire, and 2 injuries.
For comparison, the 1992 Grand Marquis has the most brakes complaints of any year, with 48.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Sep 2009105,000 milesINFire
I began smelling smoke while driving 1994 Grand Marquis. After approx. 30 seconds of smelling smoke, flames and smoke came out of rear left of hood. Brakes did not work. Car coasted into an intersection and stopped. I immediately exited the car, called 911 and waited for fire department to respond. The engine compartment was totally engulfed in flames. Fire department was able to put fire out. Entire engine compartment was burned extensively, mostly on left side. Left front tire was burned and deflated. Fire appears to have started under master brake cylinder.
Owner complaint 10283668 filed with NHTSA
BrakesFiled Jul 200894,000 milesOH
Tl*the contact owns a 1994 Mercury Grand Marquis. While backing up AT 5 MPH, the contact depressed the brake pedal and the pedal extended to the floorboard. The vehicle would not stop and he noticed brake fluid leaking. Upon further investigation, he discovered that the master cylinder was below the maximum level. He refilled the brake fluid, but the failure persisted. The contact located a recall describing the exact same failure, but ford stated that his VIN was not included in NHTSA campaign ID number 94v152000 (service brakes, hydraulic:foundation components). The failure and current mileages were 94,000.
The nuts and bolts that attach the rear brake adaptor to the axle housing flange CAN loosen and eventually separate. If one or more of the nuts come off the bolts, damage to the parking brake assembly or to the antilock brake system (ABS) sensor and sensor ring (if so equipped) will occur. If all four nuts on one end of the axle come off the bolts, damage to the brake hydraulic line or the parking brake cable CAN occur.
Risk and remedy
Risk
Occurrence of any of these conditions CAN result in a loss of braking capability and possible accident.
Remedy
Dealers will inspect and, if needed, install new bolts. If any of the fasteners are disconnected, the parking brake and ABS components will be inspected and serviced.