Owners of the 1997 Mercury Mystique have reported 7 electrical problems to NHTSA, 10% of all complaints about this model year.
Where owners named a specific part, the most common were wiring (5), ignition (1), and instrument cluster/panel (1).
The typical report came at around 78,000 miles, and complaints were filed between August 1999 and November 2006.
These electrical complaints include 2 fires.
For comparison, the 1995 Mystique has the most electrical complaints of any year, with 73.
Batteries, alternators, wiring, fuses, ignition, instrument clusters, infotainment and body electronics, including warning lights and parasitic drain.
1 recall for this model year involves the electrical.
If your problem matches, a dealer repairs it free under the recall.
Complaints7
Typical mileage78k
Crashes / fires0 / 2
Injuries0
Parts named in these complaints
Wiring5
Ignition1
Instrument Cluster/Panel1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Electrical systemFiled Nov 200694,000 milesAL
Dt*: the contact stated while traveling various speeds, the overdrive activated on and off. The vehicle was taken to an independent repair shop, where a certified mechanic determined that either the inside or outside sensor of the automatic transmission was faulty. There was a NHTSA recall #98v233000, regarding the powertrain: automatic transmission: lever and linkage: floor shift. The manufacturer was contacted and determined that the vehicle was not included in the recall due to the VIN. Also, the clock light on the insrument panel went permanently out.
Owner complaint 10173033 filed with NHTSA
Electrical systemFiled Jun 200362,000 milesNJ
Car engine while driving just stops. Dealer CAN't find the problem after numerous tries. Car will immediately re-start but this condition may cause a serious accident if not corrected.
On certain my 1996-1998 passenger vehicles built AT the kansas city, cuautitlan assembly plants or on my 1999 passenger vehcles built AT the automotive alliance international assembly plants, the rough surface of the heater blower resistor's stainless steel blades CAN damage the copper surface of the wiring harness connector. The damage could, over time, cause increased resistance in the connector and, due to subsequent terminal relaxation, result in an open circuit condition.
Risk and remedy
Risk
The open circuit could lead to electrical arcing that could melt the connector housing material creasing the potential for a fire.
Remedy
Dealers will install a new heater blower resistor and a new wire jumper harness. Owner notification began august 29, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
Filed by
FORD MOTOR COMPANY (manufacturer number 01S22)
Electrical system complaints across Mystique years