There are 8 safety recalls on file for the 1998 Mercury Mystique,
filed between February 1998 and August 2001.
Each one is repaired free by a franchised Mercury dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1998 Mystique is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2001 (2)
Vehicle description: passenger vehicles built AT the kansas city assembly plant and originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin, and the district of columbia. The front coil springs may fracture as a result of corrosion in high corrosion environments. Depending on the location of the fracture, a broken spring could move past the spring seat and contact a front tire.
Risk and remedy
- Risk
- Some tires have deflated due to contact with a broken spring.
- Remedy
- Dealers will install spring catcher brackets. Owner notification began october 23, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-866-436-7332.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 01S23)
On certain my 1996-1998 passenger vehicles built AT the kansas city, cuautitlan assembly plants or on my 1999 passenger vehcles built AT the automotive alliance international assembly plants, the rough surface of the heater blower resistor's stainless steel blades CAN damage the copper surface of the wiring harness connector. The damage could, over time, cause increased resistance in the connector and, due to subsequent terminal relaxation, result in an open circuit condition.
Risk and remedy
- Risk
- The open circuit could lead to electrical arcing that could melt the connector housing material creasing the potential for a fire.
- Remedy
- Dealers will install a new heater blower resistor and a new wire jumper harness. Owner notification began august 29, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 01S22)
2000 (1)
Vehicle description: passenger vehicles not equipped with the anti-lock braking system (ABS). A pressure conscious reducing valve (pcrv) in the rear brakes may be subject to corrosion and result in malfunction, when operated in areas that use salt compounds on the roadway for de-icing or dust control.
Risk and remedy
- Risk
- If both pcrv's malfunction, vehicle handling could be adversely affected during braking as a result of the rear wheels locking, increasing the risk of a crash.
- Remedy
- Dealers will install improved pcrv's in the rear brake system. This recall was expanded in september 2000 to include 1999 and 2000 ford contour, mercury mystique and cougar vehicles.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S03)
1999 (3)
Vehicle description: passenger vehicles. The air bag sensor wiring pigtail insulation CAN become brittle and crack over time due to accumulation of water in the pigtail protective convolute in combination with high underhood temperatures related to the routing of the wiring pigtail near the radiator. This CAN result in environmental stress cracking of the insulation.
Risk and remedy
- Risk
- In some cases, the air bag warning light CAN illuminate and the air bag supplemental restraint system disabled.
- Remedy
- Dealers will install air bag sensors with revised wiring insulation. In addition, vehicles which have the air bag warning light illuminated will have a new air bag diagnostic monitor installed.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 99S23)
99V194000
Filed Jul 20, 1999 159,565 vehicles
Vehicle description: passenger vehicles. The accelerator cable may have been manufactured with a burr on or near the end of the cable sleeve interior. This burr could fray the core wire resulting in the accelerator not returning to idle when the accelerator is released.
Risk and remedy
- Risk
- This condition CAN result in the throttle sticking, binding, or causing high engine RPM.
- Remedy
- Dealers will install a revised accelerator cable that has a flared conduit sleeve end and molded on end fitting.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 99S19)
Vehicle description: passenger vehicles. The terminals AT the headlight switch and wiring harness connector CAN experience heat damage as a result of overheating.
Risk and remedy
- Risk
- The damage could result in distortion of the terminal causing an open circuit in the instrument panel illumination, parking lamp, and tail lamp circuits.
- Remedy
- Dealers will install a headlamp switch wiring connector containing bronze terminals and an inspection, and replacement if necessary, of the headlamp switch.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 99S14)
1998 (2)
98V233000
Filed Sep 18, 1998 175,000 vehicles
Vehicle description: passenger vehicles. The floor shift automatic transmission control CAN be damaged if subjected to certain interior cleaning products. The gear position indicator CAN deteriorate and not correctly indicate the actual gear position.
Risk and remedy
- Risk
- This condition CAN result in incorrect gear selection.
- Remedy
- Dealers will replace the automatic transmission floor shift control.
- Filed by
- FORD MOTOR COMPANY
98V028000
Filed Feb 10, 1998 571,800 vehicles
Vehicle description: passenger vehicles. The text and/or graphics for the vehicle headlamp aiming instructions provided in the owner guides are not sufficiently clear. This does not meet the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment."
Risk and remedy
- Risk
- If the headlamp assemblies are replaced, customers may be confused by the aiming instructions provided in the owner guides causing the headlamps to be improperly aimed.
- Remedy
- Owner guides containing revised aiming instructions will be mailed to owners of these vehicles.
- Filed by
- FORD MOTOR COMPANY
Recall questions
How many recalls does the 1998 Mercury Mystique have?
NHTSA lists 8 recalls for the 1998 Mercury Mystique.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.