Owners of the 1996 Mercury Sable have reported 69 transmission problems to NHTSA, 23% of all complaints about this model year.
Where owners named a specific part, the most common were automatic transmission (61), manual transmission (4), and axle assembly (1).
The typical report came at around 90,000 miles, and complaints were filed between May 1996 and October 2017.
These transmission complaints include 1 crash, 2 fires, and 1 injury.
For comparison, the 1991 Sable has the most transmission complaints of any year, with 101.
Automatic and manual transmissions, CVTs, clutches, axles, driveshafts and transfer cases: harsh or delayed shifts, slipping, shuddering and rolling away in park.
3 recalls for this model year involve the transmission.
If your problem matches, a dealer repairs it free under the recall.
Complaints69
Typical mileage90k
Crashes / fires1 / 2
Injuries1
Parts named in these complaints
Automatic Transmission61
Manual Transmission4
Axle Assembly1
Driveline1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Transmission and drivetrainFiled Oct 2017300,000 milesAR
Just bought a Mercury Sable 1996. After driving this vehical for about 10 miles, the transmission began to slip badly. It began with having trouble accelerating from a complete stop. Luckily I was driving in a rural area with few stops and little traffic. By the time I stopped AT the 3 stop sign. The transmission would no longer engage into 1st or 2nd gear. Never got into 4th gear. But had to get push the vehical from the last stop sign until I reached a small hill that allowed me to reach the speed so that 3rd was able to engage and was able to make it to my house. The car hasn't moved since then. Waste of $1,000!! Transmission is finished.
Owner complaint 11034494 filed with NHTSA
Transmission and drivetrainFiled Sep 2009140,000 milesNJFire
Tl*the contact owns a 1996 Mercury Sable wagon. The contact stated the vehicle had been parked on sept 10,09 AT 3:30, the next day, AT 6:30 PM the vehicle caught fire. The vehicle was engulfed in flames. There were no injuries. The fire department extinguished the fired and stated that it was as electrical fire. A fire report is available if needed. The manufacturer was not notified. The insurance has not advised the contact if the vehicle was destroyed or not. An insurance adjuster will provide the findings as soon as possible. The failure mileage was 140,000. Updated 10/20/09 *cn the consumer stated the transmission was replaced twice.
Owner complaint 10283986 filed with NHTSA
Transmission and drivetrainFiled Oct 2005GA
(1) car shifts hard during acceleration and deceleration. Speedometer does not work or bounces up, then down. Check engine light comes on. (2) while driving AT normal road speeds the transmission will switch to low gear causing sudden throw of driver inside car and AT times when trying to accelerate there is a long delay in power to engine then sudden acceleration. (3) replaced cam sensor and other sensor three times and always fails again.
The automatic transmission park pawl shaft may not be free to rotate as intended. If the park pawl shaft does not rotate, it would prevent the park pawl from engaging the park gear when the shift lever is in the park position.
Risk and remedy
Risk
This condition could result in the vehicle rolling as if in neutral with the shift lever in the park position.
Remedy
Dealers will inspect the park pawl shaft rotation and those shafts with restricted rotation will be replaced with a shorter shaft that will not restrict rotation.
The park pawl abutment bracket has a sharp edge which CAN cause the parking pawl to hang up and not engage the park gear. This would allow the vehicle to move even though the gear shift indicator shows that the vehicle is in park.
Risk and remedy
Risk
Unintended and unexpected vehicle movement CAN result in personal injury and property damage.
Remedy
Dealers will inspect and, if necessary, replace the park pawl abutment bracket.
The park pawl shaft was improperly positioned when the roll pin that retains it was installed during transmission assembly. If the shaft was not properly positioned, the roll pin may not have lined up with the groove in the shaft and have been crushed AT assembly. Also, a burr could have been raised on the shaft.
Risk and remedy
Risk
This could result in the park pawl occasionally not engaging when the transmission selector lever is placed in the park position. This could result in the vehicle rolling as if in neutral if the vehicle operator does not apply the parking brake.
Remedy
Dealers will inspect the park pawl shaft roll pin. If the roll pin is damaged, both the roll pin and the park pawl shaft will be replaced. In addition, owners will be reminded to fully apply the parking brake, in addition to placing the transmission in park.
Filed by
FORD MOTOR COMPANY (manufacturer number 96S39)
Transmission and drivetrain complaints across Sable years