Owners of the 1999 Mercury Villager have reported 18 lighting problems to NHTSA, 10% of all complaints about this model year.
Where owners named a specific part, the most common were headlights (6), tail lights (4), and turn signal (4).
The typical report came at around 46,000 miles, and complaints were filed between February 2000 and November 2009.
For comparison, the 1994 Villager has the most lighting complaints of any year, with 26.
Headlights, taillights, brake lights, turn signals and interior lighting, including bulbs, housings and wiring.
1 recall for this model year involves the lighting.
If your problem matches, a dealer repairs it free under the recall.
Complaints18
Typical mileage46k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Headlights6
Tail Lights4
Turn Signal4
Brake Lights4
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
LightsFiled Nov 2009MA
1999 Mercury Villager mini van problem headlights keep blowing out, cannot use high beams without hearing some crackling on highbeam switch when putting on high beams. I just replace the bulb and not use highbeams. Also gas pedal sticks most of the time when you excel especially when it is damp out, I step on the pedal and it jerks forward because it's stuck when I feel it is stuck when excelling from stop I usually step on the brake then the gas and let off the brake slowly. I have been lucky there hasn't been an accident yet.
Owner complaint 10293666 filed with NHTSA
LightsFiled Mar 20055,000 milesOR
NHTSA recall campaign 99v347001 tail lamp socket. Vehicle experienced a problem with the rear tail light socket. The socket locking tab will not hold the bulb in position ,thus allowing the bulb to fall out of the socket indicating that the tail light was not functioning properly. Also, this vehicle was not covered under recall due to VIN. Due to the VIN although it was experiencing the same defects as those described in the recall.
Vehicle description: minivans. The tail light socket may have been improperly molded, resulting in the locking tab having insufficient force to retain the bulb.
Risk and remedy
Risk
If the bulb falls out of the socket, the brake or tail lamp function cannot occur.