Owners of the 2002 Mitsubishi Diamante have reported 9 electrical problems to NHTSA, 7% of all complaints about this model year.
Where owners named a specific part, the most common were wiring (1).
The typical report came at around 50,000 miles, and complaints were filed between April 2004 and February 2015.
These electrical complaints include 1 crash.
No other Diamante year has as many electrical complaints.
Batteries, alternators, wiring, fuses, ignition, instrument clusters, infotainment and body electronics, including warning lights and parasitic drain.
1 recall for this model year involves the electrical.
If your problem matches, a dealer repairs it free under the recall.
Complaints9
Typical mileage50k
Crashes / fires1 / 0
Injuries0
Parts named in these complaints
Wiring1
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Electrical systemFiled Feb 201565,289 milesNJ
Tl* the contact owns a 2002 Mitsubishi Diamante. While driving AT 45 MPH, the vehicle stalled without warning. The vehicle was taken to the dealer for diagnostic testing. The dealer was unable to diagnose the cause of the failure and stated that the VIN was not included in NHTSA campaign number: 02v100001 (electrical system.) the manufacturer was made aware of the failure. The failure mileage was 65,289.
Owner complaint 10684089 filed with NHTSA
Electrical systemFiled Oct 2012140,000 milesSCCrash
Tl* the contact owns a 2002 Mitsubishi Diamante. The contact stated that while driving AT 75 MPH, the contact attempted to brake but the brakes failed to respond without any warnings. The vehicle crashed into a passenger van. The vehicle was destroyed. The contact mentioned that two months prior to the failure the check engine light had illuminated. The vehicle was taken to an independent mechanic for diagnosis and was informed that the vehicle misfires, needed spark plugs, a fuel pump, a fuel injector, an EGR valve, and the engine surged erratically. The failure and current mileage was 140,000. Updated 12/06/12*lj updated 12/6/2012
On certain passenger vehicles, the main under hood electrical wiring harness may have insufficient clearance between the engine control harness and the exhaust heat shield. As a result, the harness could come in contact with the heat shield, which could result in melting of the harness insulation.
Risk and remedy
Risk
The melting of the harness insulation could result in grounding of the crank angle sensor wiring, causing the engine to run erratically or stop suddenly, increasing the risk of a crash.
Remedy
Dealers will inspect the harness for damage and, if none is evident, will tie the harness back to prevent the harness from ever coming into contact with the heat shield. Any harness that shows evidence of damage will be repaired as necessary and then tied back to prevent future damage. Owner notification began may 13, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact mitsubishi AT 1-800-222-0037.
Filed by
MITSUBISHI AMERICA
Electrical system complaints across Diamante years