Owners of the 1998 Mitsubishi Galant have reported 8 suspension problems to NHTSA, 15% of all complaints about this model year.
Where owners named a specific part, the most common were front (7).
The typical report came at around 123,000 miles, and complaints were filed between May 2001 and September 2011.
These suspension complaints include 2 crashes and 2 injuries.
For comparison, the 1995 Galant has the most suspension complaints of any year, with 69.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints8
Typical mileage123k
Crashes / fires2 / 0
Injuries2
Parts named in these complaints
Front7
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Sep 2011150,000 milesWA
Tl* the contact owns a 1998 Mitsubishi Galant. The contact stated that the front passenger side lower ball joint failed. The contact stated that the nut that held the lower ball joint became loose and detached, causing the lower ball joint failure. The vehicle had been repaired three times prior for the same exact failure. The manufacturer extended the warranty for the part for a lifetime however, the contact believed the failure to be an extreme safety issue because the part would become loose very easily. The VIN was not available. The failure mileage was 150,000.
Owner complaint 10427210 filed with NHTSA
SuspensionFiled Apr 2004104,810 milesMD
In November 2003, while driving between 20 to 25 MPH, front passenger tire fell off, vehicle was towed to independent mechanic, who determined that ball joints failed. In April 2004 consumer received a recall letter notice concerning ball joint problem.
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water CAN intrude. Also, mmc has added the potential of leaking moisture, which CAN cause the ball stud to corrode.
Risk and remedy
Risk
This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v-066.
Remedy
Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.