1993 Mitsubishi Montero Problems
Special purpose vehicle · 4WD/AWD · Regular
Owners have filed 14 complaints about the 1993 Mitsubishi Montero with NHTSA's vehicle safety hotline and website. The engine leads with 8, then the steering with 5.
One complaint can name more than one system, so the groups below add up to more than the total. Open a group for the parts owners name, the mileage and their own words.
Latest owner reports
Dt*: the contact stated while parked with the engine idling, it was noticed that the pulley for the power steering was loose. As the contact already had the recall # 00v311001, regarding engine and engine cooling:engine repairs performed once, the vehicle was taken to the dealership who determined the crankshaft had to be tighten again. The contact expressed concern because the bolt was replaced and tightened before and the problem should not have recurred. The manufacturer was contacted who refused to cover the repair a second time under the recall.
Dt*: the contact stated while parked with the engine idling, it was noticed that the pulley for the power steering was loose. As the contact already had the recall # 00v311001, regarding engine and engine cooling:engine repairs performed once, the vehicle was taken to the dealership who determined the crankshaft had to be tighten again. The contact expressed concern because the bolt was replaced and tightened before and the problem should not have recurred. The manufacturer was contacted who refused to cover the repair a second time under the recall.
Pulled out of driveway and proceeded forward when the right wheel did not steer. Drove vehicle back into driveway. Passenger side inner tie-rod pulled out of the treaded tube. Ordered parts to replace both inner and outer tie-rods with connecting threaded tube. It's a good thing it didn't happen AT highway speed!
Addition to complaint 10088338. Fter having the vehicle checked by my mechanic, the problem is that the bolt (the one listed in the original recall) backed out of the crank shaft causing the pully to wobble (distroying the pulley in the process). Once the bolt was 3/4 of the way out, it snapped in two.