Owners of the 2003 Nissan 350z have reported 60 engine problems to NHTSA, 22% of all complaints about this model year.
Where owners named a specific part, the most common were engine (6) and exhaust system (2).
The typical report came at around 83,000 miles, and complaints were filed between March 2004 and November 2025.
No other 350z year has as many engine complaints.
Engine and cooling: stalling, loss of power, oil consumption, overheating, knocking, failed internal parts and check-engine faults traced to the engine.
1 recall for this model year involves the engine.
If your problem matches, a dealer repairs it free under the recall.
Complaints60
Typical mileage83k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Engine6
Exhaust System2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
EngineFiled Nov 2025AL
Vehicle shut off automatically going down interstate coming home from Mississippi. The car stoped running and would not crank back. Radiator fluid spuing all over the ground running hot but did not show overheating temp on dash never showed no over heating temp on gauges or nothing. Motor cranked up days later and was knocking due to knocking.
Owner complaint 11697016 filed with NHTSA
EngineFiled Mar 2021139,000 milesFL
My car for the last year will drive 5-7 miles and stall in regular traffic. We replaced the fuel pump. I finally have enough $ to take to Nissan. They came back with it needs all 2 cam shaft sensors and crank shaft sensor replaced. When I go on line and search my 2003 350z touring edition recall, there was a recall for this problem as it appears the wires CAN break inside due to temp on solder joints. I would like to know if this is this a problem that was noted on a recall and this is an ongoing problem with this same model, why now AM I going to pay Nissan $1200 for the repair that should be covered. I need this investigated
Owner complaint 11399483 filed with NHTSA
EngineFiled Mar 201964,000 milesOH
Tl* the contact owns a 2003 Nissan 350z. While driving various speeds, the vehicle lost power and took numerous attempts to restart. In addition, the traction control, flip, and check engine warning indicators illuminated. The failure occurred intermittently. Numerous unknown dealers and independent mechanics were notified, but the vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 64,000.
On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
Risk and remedy
Risk
This could cause the "service engine soon" warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.
Remedy
Dealers will replace the crank position sensors. Camshaft position sensor(s), and in some cases, the variable timing control sensor(s). Vehicles involved in a previous recall campaign, 01v357, are also included in this new campaign. The replacement sensors used in that campaign are also affected. Owner notification began on december 22, 2003. Owners should contact nissan AT 1-800-647-7261 or infiniti AT 1-800-662-6200.
Filed by
NISSAN NORTH AMERICA, INC. (manufacturer number R3021/R3022)