Oldsmobile · Cutlass Supreme

1996 Oldsmobile Cutlass Supreme Recalls

Midsize car · FWD · Regular

There are 2 safety recalls on file for the 1996 Oldsmobile Cutlass Supreme, filed between July 2000 and December 2003. Each one is repaired free by a franchised Oldsmobile dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1996 Cutlass Supreme is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

2003 (1)

03V527000 Filed Dec 11, 2003 750,283 vehicles

Rack and pinion

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

Risk and remedy
Risk
If this occurs, the pinion shaft CAN be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver CAN encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
Remedy
Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick AT 1-866-608-8080; chevrolet AT 1-800-630-2438; oldsmobile AT 1-800-630-6537; or pontiac AT 1-800-620-7668.
Filed by
GENERAL MOTORS CORP. (manufacturer number 03062)

2000 (1)

00V171000 Filed Jul 3, 2000 268,146 vehicles

Frontal

Vehicle description: passenger vehicles. Corrosion of the air bag inflator's internal wiring, which CAN occur over time, could cause the inadvertent deployment of the driver's air bag. This deployment could occur during vehicle start-up, while the vehicle is parked or idling, or while in operation.

Risk and remedy
Risk
If the consumer is too close to an inflating air bag, serious injuries could occur.
Remedy
Dealers will replace the inflators on these air bags.
Filed by
GENERAL MOTORS CORP. (manufacturer number 00058)

Recall questions

How many recalls does the 1996 Oldsmobile Cutlass Supreme have?

NHTSA lists 2 recalls for the 1996 Oldsmobile Cutlass Supreme.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.