Owners of the 1994 Oldsmobile Cutlass have reported 36 brakes problems to NHTSA, 24% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (19), antilock/traction control/electronic limited slip (19), and power assist (2).
The typical report came at around 89,000 miles, and complaints were filed between February 1995 and August 2005.
These brakes complaints include 2 crashes and 1 injury.
For comparison, the 1991 Cutlass has the most brakes complaints of any year, with 60.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 200562,217 milesKS
I have a 94 Cutlass olds with only 62,000 miles on it. The brakes do not work properly. When stepping on the brake pedal the car surges forward and then stops. Today I almost hit kid crossing the street. I have reported this problem before. The dealer cannot find anything wrong. I just had my brakes replaced all the way around and the problem is still there. I had them replaced on 8-16-05. This does not do it all the time so there is no warning when they are not going to stop right away. I checked your site and there are 16 complaints on the brakes.
Owner complaint 10134183 filed with NHTSA
BrakesFiled Dec 2003115,430 milesNY
The antilock brakes on my 1994 Oldsmobile Cutlass cruiser make the car impossible to stop on an icy road. AT very low speeds, 15 MPH or less once the antilock breaks kick in the car takes off and slides right through the intersection this behavior is unpredictable, scary and quite dangerous. The tires and brakes are new and in good condition. Disabling the antilock breaks makes the car very easy to stop under the same conditions even if a wheel skids a little bit. This isn't an equipment failure as much as it is a defect in design concept.
Owner complaint 10049138 filed with NHTSA
BrakesFiled Jul 2001MA
The vehicle pulsates when applying brakes, consumer was informed that the rear brakes were inoperable and were replaced, calipers were overhauled, front rotors were resurfaced, also rear rotors were resurfaced.
The brake lines CAN contact the transmission mounting bracket of the frame side rail. The lines CAN wear through resulting in loss of brake fluid, and eventual loss of half the vehicle braking system.
Risk and remedy
Risk
A leak in the hydraulic brake line will cause a loss of one half the vehicle braking system and extended braking distances which CAN result in an accident.
Remedy
Dealers will inspect for proper brake line clearance and reposition the brake lines. Brake lines found to have indentations will be replaced.