There are 3 safety recalls on file for the 1993 Oldsmobile Silhouette,
filed between January 1994 and January 1996.
Each one is repaired free by a franchised Oldsmobile dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1993 Silhouette is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1996 (1)
96V015000
Filed Jan 23, 1996 585,182 vehicles
Vehicle description: passenger vehicles manufactured from august 1991 through july 1995. The transmission oil cooler line CAN separate when the vehicle is operated in low temperatures in combination with high transmission loads.
Risk and remedy
- Risk
- Vehicle fires CAN occur due to the spillage of transmission fluid.
- Remedy
- Dealers will replace the transmission oil cooler lines.
- Filed by
- GENERAL MOTORS CORP.
1994 (2)
The second row, right hand shoulder belt CAN become "pinched" between the seat and the door frame pillar trim. The shoulder belt may not retract properly, which does not comply with the requirements of fmvss no. 208, "occupant crash protection." the 1994 vehicles have an optional integral (built in) childseat installed next to the power sliding side door. The 1993 involved vehicles have standard seats in that same position.
Risk and remedy
- Risk
- Improper shoulder belt retraction does not provide adequate protection to the seat occupant in the event of a sudden stop or collision.
- Remedy
- Dealers will replace the door frame pillar trim panel with a redesigned trim panel. Also, a caution label will be applied to the child seat advising the owner not to install the seat to the passenger side of a vehicle with a power sliding side door.
- Filed by
- GENERAL MOTORS CORP.
Vehicle fails to conform to fmvss no. 209, "seat belt assemblies." the safety belt of the left third row seat on the six passenger van and the center second row seat of the seven passenger van may lock up and cannot be withdrawn from the retractor.
Risk and remedy
- Risk
- Consequence of non-compliance: the occupants of these seats will not be able to use the affected belt. In the event of a vehicle crash, unbelted occupants are AT increased risk of injury.
- Remedy
- Owners are being asked to inspect their vehicles to determine if the suspect retractor exhibits a lockup condition. Based on this inspection, dealers will replace the safety belts if the belt locks up. Replacement of the suspect safety belt will be available to consumers for the life of the vehicle.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1993 Oldsmobile Silhouette have?
NHTSA lists 3 recalls for the 1993 Oldsmobile Silhouette.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.