Owners of the 1998 Plymouth Breeze have reported 15 brakes problems to NHTSA, 9% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (13), antilock/traction control/electronic limited slip (2), and conventional (1).
The typical report came at around 7,000 miles, and complaints were filed between October 1998 and August 2006.
These brakes complaints include 1 crash, 1 fire, 2 injuries, and 1 death.
For comparison, the 1996 Breeze has the most brakes complaints of any year, with 22.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 2006
Right rear brake problem. Brake would come on but not release. The problem was solved by this website and information from another person's complaint, see below. The flex line going to the wheel has a bracket attached and this was crimped too tight, pinching off the line. Brake fluid was getting through enough to apply the brake, but not flowing back to release the brakes. The problems were many and the following had to be replaced; excessive heat destroyed the wheel cylinder, the wheel bearing, the shoes, the springs and hold down kit and brake drum. Another person's complaint is below.
Owner complaint 10165018 filed with NHTSA
BrakesFiled Jul 2006PA
My father in law said he was having trouble with the brakes on his 1998 Plymouth Breeze. When I looked AT the master cylinder in was almost empty. When I pulled the front wheels the left pad was worn a good bit more than the right. When I pulled the rear wheels the right shoes were cracked and the left wheel cylinder was leaking. I made all the repairs but I couldn't get a proper bleed on the rear brakes. Further looking showed the right rear brake was locking up than slowly releasing. Looking even closer I found that the rear brake hoses on both sides were plugged up AT the point were the hose was crimped to the bracket.
Vehicle description: passenger vehicles. The right rear brake tube CAN contact the exhaust system clamp and wear a hole in it.
Risk and remedy
Risk
Daimlerchrysler recall no. 843. If this happens, the tube could leak, reducing the effectiveness of one-half of the diagonally split braking system, and resulting in longer stopping distances.
Remedy
Dealers will inspect the brake tubes for visible evidence of contact with the exhaust system clamp. If the tube shows evidence of contact, it will be replaced. If no evidence of contact exists, the tube will be fastened with a clip.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 843)