Owners of the 1995 Pontiac Sunfire have reported 5 suspension problems to NHTSA, 4% of all complaints about this model year.
Where owners named a specific part, the most common were front (5).
The typical report came at around 52,000 miles, and complaints were filed between March 1997 and October 2003.
For comparison, the 1997 Sunfire has the most suspension complaints of any year, with 12.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints5
Typical mileage52k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Front5
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Oct 200351,867 milesAZ
While making a left turn AT a stop sign and without warning left front lower ball joint snapped in two. When this occurred, left wheel almost came completely off.
Owner complaint 10042887 filed with NHTSA
SuspensionFiled May 2002TX
Vehicle is leaking water from head gasket. Coolant light illuminates on dash. Took to dealer. Also there was a recall campaign 00v367000. *ak dealer found small hole in cylinder head. Engine will not start and is overheating. Vehicle shuts off AT stop. Vehicle shuts off while driving. Alternator, ignition switch, head gasket, coolant, fan belt, plugs and water pump was replaced. Found front hub bearing making roaring noise. A/C stop working. Dealer found compressor failed. There is a strong gas odor when cranking vehicle. Fuel injector was replaced.
These vehicles have been built with welds missing from the front suspension lower control arm assemblies causing excessive loads on the existing welds.
Risk and remedy
Risk
This condition CAN result in separation of the frontbushing sleeve subassembly from the control arm increasing the potential for a vehicle crash.
Remedy
Dealers will inspect both left-hand and right-hand front suspension lower control arm assemblies and replace all control arm assemblies found with omitted welds.