1991 Toyota 4Runner Problems
Special purpose vehicle · 4WD/AWD, RWD · Regular
Owners have filed 43 complaints about the 1991 Toyota 4Runner with NHTSA's vehicle safety hotline and website. The engine leads with 20, then the brakes with 6. Reports for this year mention 3 crashes and 4 injuries.
One complaint can name more than one system, so the groups below add up to more than the total. Open a group for the parts owners name, the mileage and their own words.
- Engine 47% of complaints · median 173,000 miles · Engine 20
- Brakes 14% of complaints · median 136,000 miles · Foundation Components 6
- Steering 12% of complaints · median 170,000 miles · Linkages 5
- Transmission and drivetrain 12% of complaints · median 260,000 miles · Clutch Assembly 5
- Tires 9% of complaints · Tread/Belt 4
- Wheels 5% of complaints · median 261,000 miles 2
- Body and structure 2% of complaints · median 164,000 miles · Frame And Members 1
- Equipment and accessories 2% of complaints · median 154,000 miles 1
- Visibility and wipers 2% of complaints · Windshield Wiper/Washer 1
- Fuel system 2% of complaints 1
- Speed control 2% of complaints · median 154,000 miles 1
Latest owner reports
While driving in the street AT 40 MPH, it accelerates for no reason. I could not stop, the brake put hard, did not respond to any change and engine speed increased to more than 5000. I had to turn it off still running. To turn it back on, it will not do so again.
Brought my 1991 4Runner into concord (ca) Toyota dealer for recall NHTSA campaign ID number : 05v389000, for :component: steering:linkages:rod:relay:connecting after receiving the vehicle, there is too much "play" (movement) in the steering wheel, and the front wheels "wobble" badly in certain situations, creating unsafe driving conditions. The problems appear to be front end-end/alignment related. I did not have these problems prior to taking this is in for the recall.
1991 Toyota 4Runner steering failed when turning wheel. *ts ***no answer required*** the consumer received a recall notice regarding the steering linkages two months after the accident.
Corrosion on the break lines from poor design in allowing sand and dirt to accumulate and cause the line to rust through and create a break failure. The rust created a little larger then a pin hole that aloud the rapid lost of break fluid which caused the loss of stopping and almost caused sever damage and injury to same.