Owners of the 2001 Toyota Echo have reported 9 engine problems to NHTSA, 18% of all complaints about this model year.
Where owners named a specific part, the most common were engine (3) and cooling system (2).
The typical report came at around 109,000 miles, and complaints were filed between June 2001 and December 2018.
These engine complaints include 3 crashes, 4 fires, and 2 injuries.
No other Echo year has as many engine complaints.
Engine and cooling: stalling, loss of power, oil consumption, overheating, knocking, failed internal parts and check-engine faults traced to the engine.
1 recall for this model year involves the engine.
If your problem matches, a dealer repairs it free under the recall.
Complaints9
Typical mileage109k
Crashes / fires3 / 4
Injuries2
Parts named in these complaints
Engine3
Cooling System2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
EngineFiled Dec 2018155,000 milesOK
Tl* the contact owns a 2001 Toyota Echo. While driving various speeds, the air bag and check engine indicators illuminated. The contact also stated that the gear shift indicator did not illuminate when changing gears. The vehicle was taken to a repair shop where the computer was reset, but the failure recurred. The vehicle was not repaired. The dealer and manufacturer were not made aware of the failure. The failure mileage was 155,000.
Owner complaint 11155661 filed with NHTSA
EngineFiled Dec 2011225,000 milesVA
Tl* the contact owns a 2001 Toyota Echo. The contact stated that when driving AT various speeds above 5 MPH and operating the headlights, the vehicle would stall without warning. The vehicle was able to be restarted after a jump and was not inspected by a dealer nor repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 225,000. The VIN was unavailable.
On certain passenger vehicles, due to improper molding of the resin body of the crankshaft position senor installed on the engine block, engine oil may penetrate the seal and enter the sensor wiring connector. The wire harness connector may not be sufficiently attached to the locking tab of the sensor wiring connector.
Risk and remedy
Risk
Engine oil inside the sensor wiring connector could cause expansion due to the heat of the engine and could deform the sensor wiring connector. The connector may become disconnected, which could cause the engine to stall while driving and not be able to be restarted increasing the risk of a crash.
Remedy
Dealers will replace the crankshaft position sensor free of charge. The recall began on july 26, 2006. Owners may contact toyota AT 1-800-331-4331.
Filed by
TOYOTA MOTOR NORTH AMERICA, INC. (manufacturer number 60G)