Owners of the 2001 Toyota Prius have reported 20 engine problems to NHTSA, 12% of all complaints about this model year.
Where owners named a specific part, the most common were engine (4) and exhaust system (2).
The typical report came at around 39,000 miles, and complaints were filed between August 2003 and September 2017.
These engine complaints include 2 crashes and 1 injury.
For comparison, the 2010 Prius has the most engine complaints of any year, with 173.
Engine and cooling: stalling, loss of power, oil consumption, overheating, knocking, failed internal parts and check-engine faults traced to the engine.
1 recall for this model year involves the engine.
If your problem matches, a dealer repairs it free under the recall.
Complaints20
Typical mileage39k
Crashes / fires2 / 0
Injuries1
Parts named in these complaints
Engine4
Exhaust System2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
EngineFiled Sep 2017WACrash
Tl* the contact owns a 2001 Toyota Prius. While driving 20 MPH, the vehicle lost complete power and braking ability without warning. As a result, the contact drove over the median aand crashed into a pole. The air bags deployed. A police report was filed. There were no injuries. The vehicle was towed to the local dealer (titus-will Toyota, 3506 s sprague ave, tacoma, wa 98409). The vehicle was not declared destroyed. The manufacturer was not contacted. The failure mileage and VIN were unknown.
Owner complaint 11024048 filed with NHTSA
EngineFiled Dec 2012160,000 milesMD
If the Prius engine does not start immediately when the computer tells it to, the computer stops trying to start it and leaves you with only the battery power...very dangerous when this happens in fast traffic or on an on-ramp. It CAN be restarted if one pulls off the road and shuts off the car and restarts it. After numerous incidents and attempts to determine the reason for the occasional non-starts, it turned out that the air intake flap in the engine CAN get dirty and stick, which causes the engine to sometimes take several tries to restart.
On certain passenger vehicles, due to improper molding of the resin body of the crankshaft position senor installed on the engine block, engine oil may penetrate the seal and enter the sensor wiring connector. The wire harness connector may not be sufficiently attached to the locking tab of the sensor wiring connector.
Risk and remedy
Risk
Engine oil inside the sensor wiring connector could cause expansion due to the heat of the engine and could deform the sensor wiring connector. The connector may become disconnected, which could cause the engine to stall while driving and not be able to be restarted increasing the risk of a crash.
Remedy
Dealers will replace the crankshaft position sensor free of charge. The recall began on july 26, 2006. Owners may contact toyota AT 1-800-331-4331.
Filed by
TOYOTA MOTOR NORTH AMERICA, INC. (manufacturer number 60G)