Toyota · Sequoia

2008 Toyota Sequoia Speed control Problems

SUV · 4WD/AWD, RWD · Regular

Owners of the 2008 Toyota Sequoia have reported 9 speed control problems to NHTSA, 13% of all complaints about this model year.

Where owners named a specific part, the most common were accelerator pedal (1).

The typical report came at around 45,000 miles, and complaints were filed between November 2009 and July 2026.

For comparison, the 2002 Sequoia has the most speed control complaints of any year, with 135.

Accelerator pedals, throttle bodies and cruise control: unintended acceleration, stuck throttles and surging.

1 recall for this model year involves the speed control. If your problem matches, a dealer repairs it free under the recall.
Complaints9
Typical mileage45k
Crashes / fires0 / 0
Injuries0

Parts named in these complaints

  • Accelerator Pedal1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Speed control Filed Jul 2026 IL

While accelerating to pass a vehicle that was signaling and operating well below the speed limit, my vehicle experienced sudden and continued unintended acceleration. I was able to bring the vehicle to a stop while fighting against the engine within an intersection but the engine continued building revs, bouncing off the limiter while my foot was entirely removed from the accelerator pedal and fully applied to the brake.

Owner complaint 11751908 filed with NHTSA
Speed control Filed Jan 2021 90,000 miles CA

When I'm slowing down for a red light, then the light turns green. And I hit the acceleration the car would jerk. And same thing when I make a left turn. It would jerk and feels like I have no acceleration.

Owner complaint 11386721 filed with NHTSA

Related recalls

10V017000 Filed Jan 21, 2010 2,230,661 vehicles

Accelerator pedal

Toyota is recalling certain model year 2005-2010 avalon, model year 2007-2010 camry, model year 2009-2010 corolla, corolla matrix, RAV4, model year 2010 highlander, model year 2008-2010 sequoia, and model year 2007-2010 tundra vehicles. Due to the manner in which the friction lever interacts with the sliding surface of the accelerator pedal inside the pedal sensor assembly, the sliding surface of the lever may become smooth during vehicle operation. In this condition, if condensation occurs on the surface, as may occur from heater operation (without A/C) when the pedal assembly is cold, the friction when the accelerator pedal is operated may increase, which may result in the accelerator pedal becoming harder to depress, slower to return, or, in the worst case, mechanically stuck in a partially depressed position.

Risk and remedy
Risk
The accelerator pedal may become hard to depress, slow to return to idle, or, in the worst case, mechanically stuck in a partially depressed position, increasing the risk of a crash.
Remedy
Dealers will install a reinforcement bar in the accelerator pedal which will allow the pedal to operate smoothly. GM will notify owners for the pontiac vibe please see 10v-018. This service will be performed free of charge. The safety recall is expected to begin on february 5, 2010 and will be completed on march 15, 2010. Owners may contact toyota AT 1-800-331-4331.
Filed by
TOYOTA MOTOR NORTH AMERICA, INC. (manufacturer number AOA)

Speed control complaints across Sequoia years

Questions about speed control problems

How common are speed control problems on the 2008 Toyota Sequoia?

9 owners have reported speed control problems to NHTSA, 13% of all complaints for this model year.

Is there a recall for speed control problems on the 2008 Toyota Sequoia?

Yes. 1 recall for this model year concerns the speed control: 10V017000.