There are 9 safety recalls on file for the 2007 Volvo VT,
filed between April 2006 and June 2013.
Each one is repaired free by a franchised Volvo dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 2007 VT is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2013 (1)
Volvo Trucks North America (Volvo) is recalling certain model year 2007-2014 VAH, VHD, VNL, VNM, and VT models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch from automatically disengaging when the brake is applied.
Risk and remedy
- Risk
- Without a signal to disengage the clutch when the brakes are applied, the distance required to stop the truck may lengthen, increasing the risk of a crash.
- Remedy
- Volvo Trucks will notify owners and dealers will inspect and repair the vehicles if necessary. The recall began on August 26, 2013. Volvo's recall number is RVXX1303. Owners may contact Volvo at 1-336-393-2000.
- Filed by
- Volvo Trucks North America (manufacturer number RVXX1303)
2010 (1)
Volvo trucks is recalling certain model year 2007 and 2009 vhd, model year 2006 through 2010 vn, and model year 2007 through 2009 vt trucks manufactured from november 7, 2005, through october 30, 2009, equipped with an air release fifth wheel. The inversion valve on the frame may be orientated where contaminants CAN enter the valve through the exhaust port. As a result, the brake valve may corrode.
Risk and remedy
- Risk
- Corrosion of the valve CAN cause it to malfunction, thereby adversely affecting braking performance and increasing the risk of a crash.
- Remedy
- Dealers will inspect the inversion valve and replace as required. This service will be performed free of charge. The safety recall is expected to begin on or before february 18, 2011. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA (manufacturer number RVXX1006)
2009 (1)
09V173000
Filed May 21, 2009 127,764 vehicles
Volvo trucks is recalling 127,764 my 2001-2008 vhd, vnl, vnm, and my 2005-2008 vt trucks. A seal may fail allowing water and contaminants to seep into the windshield wiper motor.
Risk and remedy
- Risk
- If this happens a short circuit may occur, which over time could possibly lead to a vehicle fire.
- Remedy
- Volvo will replace the wiper motor free of charge. Since this recall involves a large number of vehicles, volvo will release the recall in stages as parts are received. Priority will be given to the vehicles located in the regions/states that have a corrosive environment. The recall began on september 30, 2009. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA (manufacturer number RVXX0902)
2007 (4)
07V573000
Filed Dec 14, 2007 104,845 vehicles
On certain heavy duty trucks, the circuit protection (i.e. Automatic circuit breakers) used to protect the vehicle lighting system may not provide adequate protection.
Risk and remedy
- Risk
- If a short circuit occurs and is left untreated, components and wiring may be subject to overheating which could possibly result in a vehicle fire.
- Remedy
- Dealers will replace the circuit breakers with fuses. The recall began on february 25, 2008. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA (manufacturer number RVXX0707)
On certain trucks equipped with a saf holland simplex fifth wheel, the lever arm pivot bolt may have been over tightened. An over tightened pivot bolt CAN distort the pivot bolt spacer sleeve, which may prevent the fifth wheel latch jaw from closing and latching securely around the trailer king pin.
Risk and remedy
- Risk
- There is a possibility that the pivot bolt CAN become loose without the driver's knowledge. When this occurs, the driver could drive away and the trailer could become disengaged, increasing the risk of a crash.
- Remedy
- Dealers will replace the pivot bolt and sleeve with a hex head shoulder bolt and washer free of charge. The recall began on january 28, 2008. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA (manufacturer number RVXX0705)
On certain trucks, an unprotected lead in the thermoswitch of the heater may make contact with another post possibly creating a short circuit, which CAN result in continuous operation of the heating element.
Risk and remedy
- Risk
- If the condition exists and the key is left on without fuel in the filter, the heating element may heat to a point where a flame becomes present AT the tip of the element which could result in a vehicle fire.
- Remedy
- Dealers will inspect the thermoswitch and will replace it if necessary. The recall began on september 10, 2007. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA (manufacturer number RVXX0703)
On certain trucks, the nut used to retain the steering shaft may or may not be a lock nut that has the locking feature. A lock nut is required to provide additional resistance to ensure that the nut does not come loose.
Risk and remedy
- Risk
- If the nut were to come loose, the steering shaft could potentially separate resulting in loss of steering control which could cause a crash.
- Remedy
- Dealers will replace the steering shaft pinch bolts and locknuts free of charge. The recall began on august 24, 2007. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA (manufacturer number RVXX0702)
2006 (2)
On certain trucks equipped with arvinmeritor rpl20 high angle interaxle driveshafts, an improper seated or missing snap ring CAN result in the bearing cup to separate from the slip yoke sub-assembly. The universal joint cross could then contact the slip yoke casting and eventually cause the ear work to fracture.
Risk and remedy
- Risk
- This could result in additional damage to the driveline, the vehicle to which it is attached and ay additional nearby objects.
- Remedy
- Dealers will inspect the driveshafts and replace them as needed. The recall began on october 23, 2006. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA, INC. (manufacturer number RVXX0605)
On certain heavy duty class 8 trucks equipped with dana steering shafts, there is a potential that the steering shaft pinch bolt hole may be incorrectly located. The pinch bolt fits into a groove in the steering gear input shaft to ensure that the steering shaft does not separate from the steering gear if the pinch bolt comes loose.
Risk and remedy
- Risk
- This could potentially lead to steering shaft separation resulting in loss of control of the vehicle if the pinch bolt were to come loose increasing the risk of a crash.
- Remedy
- Dealers will inspect the steering shaft and replace it as required free of charge. The recall began on august 28, 006. Owners may contact volvo trucks AT 1-800-528-6586.
- Filed by
- VOLVO TRUCKS NORTH AMERICA, INC. (manufacturer number RVXX0602)
Recall questions
How many recalls does the 2007 Volvo VT have?
NHTSA lists 9 recalls for the 2007 Volvo VT.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.