BMW · 325

1993 BMW 325 Recalls

Subcompact car · RWD · Premium

There are 3 safety recalls on file for the 1993 BMW 325, filed between February 1993 and August 1994. Each one is repaired free by a franchised BMW dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1993 325 is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1994 (2)

94V151000 Filed Aug 10, 1994 57,000 vehicles

Anchorage

In a fmvss no. 208 30 miles-per-hour compliance test, an unbelted test driver dummy's chest maximum resultant acceleration was 70.8 g's, which exceeds the maximum allowable value of 60 g's. Also, the unbelted passenger dummy's left femur maximum load was 2361 lbs, which exceeds maximum allowable value of 2250 lbs. The vehicles do not comply with fmvss no. 208, "occupant crash protection."

Risk and remedy
Risk
Consequence of non-compliance: in the event of an accident, the occupant will be subjected to an increased risk of injury.
Remedy
On automatic transmission models only, the dealer will replace the transmission support crossmember with a crossmember used on the manual transmission model. Also, the transmission rear bushing supports will be replaced with bushing having different performance characteristics. The steering column front support bearing AT the firewall will be replaced with a modified part using a teflon inner surface and teflon spray will be applied to the column housing in the area of the bearing. A brace will be added between the knee bolster support and the steering column.
Filed by
BAYERISCHE MOTOREN WERKE
94V066000 Filed Apr 11, 1994 116,300 vehicles

Hoses, lines/piping, and fittings

Feed fuel hoses CAN harden and "set" over time, allowing a seepage of fuel AT the connection between the hose and the engine fitting. The clamp used to hold the hose to the fitting is unable to compensate for the hardening of the feed fuel hose.

Risk and remedy
Risk
Fuel seepage between the feed fuel hose and the engine fitting CAN result in free fuel in the engine compartment, which could result in a fire when exposed to a source of ignition.
Remedy
A redesigned feed fuel hose and hose clamp will be installed to alleviate the fuel seepage.
Filed by
BAYERISCHE MOTOREN WERKE

1993 (1)

93V015000 Filed Feb 1, 1993 375,000 vehicles

Heater core

The malfunction or failure of a coolant system component results in significantly increased coolant temperature and a resulting increase in system pressure.

Risk and remedy
Risk
Vehicles operated under this increased cooling systempressure condition CAN suffer damage or failure of parts of the cooling systemsuch as (1) leakage from a coolant hose, (2) leakage of the radiator orexpansion tank, (3) disconnection of a hose from a pipe or a fitting, and (4)cracks in the heater core end piece resulting in coolant leakage. In some cases,boiling coolant CAN contact the lower right leg of the driver resulting inburns. Also, escaping coolant in the passenger compartment CAN cause vaporfogging of the interior surface of the windows, reducing driver visibility.
Remedy
Dealers will install a thermostatic bypass valve in the engine compartment to control coolant temperature in the heater core. Also, a new design radiator cap will be installed, to control pressure and provide greater coolant overflow in the event of overheating.
Filed by
BAYERISCHE MOTOREN WERKE

Recall questions

How many recalls does the 1993 BMW 325 have?

NHTSA lists 3 recalls for the 1993 BMW 325.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.