There are 3 safety recalls on file for the 2001 Buick Century,
filed between August 2000 and April 2001.
Each one is repaired free by a franchised Buick dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 2001 Century is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2001 (1)
Vehicle description: certain passenger vehicles, equipped with sunvisor located air bag labels, fail to conform to federal motor vehicles safety standard no. 208, "occupant crash protection." these vehicles have a message area less than 30 cm which does not meet the requirements of the standard.
Risk and remedy
- Risk
- These vehicles do not comply with the standard.
- Remedy
- GM will mail a new bilingual air bag label with installation instructions. However, the customer may bring the label to their dealer for installation free of charge. Owner notification began may 4, 2001. Owners who do not receive the free label and installation instructions within a reasonable time should contact oldsmobile AT 1-800-442-6537 or buick AT 1-800-521-7300.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 01017)
2000 (2)
Vehicle description: passenger vehicles. Some of these vehicles exhibit a condition in which the driver side impact air bag inflator separates from the air bag module during deployment.
Risk and remedy
- Risk
- If the inflator separates, the air bag will not deploy properly during a crash and occupant protection would be reduced. If is also possible that a separated inflator could be propelled downward and could result in injury to a rear seat passenger whose foot is positioned approximately under the inflator module.
- Remedy
- Dealers will replace the side impact air bag module.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 00090)
Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
Risk and remedy
- Risk
- In the event of a vehicle crash, the occupant may not be properly restrained.
- Remedy
- Dealers will inspect the vehicle's safety belt buckle assembly date codes and, if necessary, will replace any safety belt buckle assembly.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 00067)
Recall questions
How many recalls does the 2001 Buick Century have?
NHTSA lists 3 recalls for the 2001 Buick Century.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.