Owners have filed 145 complaints about the 2001 Buick Century with NHTSA, the 5th highest of 16 Century years.
The largest share concerns the engine (31 complaints, 21% of the total), followed by brakes (26) and transmission and drivetrain (21). Half of those engine reports describe a failure before 67,000 miles.
Complaints for this year mention 9 crashes, 2 fires, and 5 injuries. These are owner reports and have not been verified by NHTSA.
NHTSA lists 3 recalls for this model year. The most recent, campaign 01V109000, was filed in April 2001 and concerns the seat belts.
EPA figures put it at up to 21 MPG combined (18 city, 26 highway), close to the average midsize car of its year.
Vehicle description: certain passenger vehicles, equipped with sunvisor located air bag labels, fail to conform to federal motor vehicles safety standard no. 208, "occupant crash protection." these vehicles have a message area less than 30 cm which does not meet the requirements of the standard.
Risk and remedy
- Risk
- These vehicles do not comply with the standard.
- Remedy
- GM will mail a new bilingual air bag label with installation instructions. However, the customer may bring the label to their dealer for installation free of charge. Owner notification began may 4, 2001. Owners who do not receive the free label and installation instructions within a reasonable time should contact oldsmobile AT 1-800-442-6537 or buick AT 1-800-521-7300.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 01017)
Vehicle description: passenger vehicles. Some of these vehicles exhibit a condition in which the driver side impact air bag inflator separates from the air bag module during deployment.
Risk and remedy
- Risk
- If the inflator separates, the air bag will not deploy properly during a crash and occupant protection would be reduced. If is also possible that a separated inflator could be propelled downward and could result in injury to a rear seat passenger whose foot is positioned approximately under the inflator module.
- Remedy
- Dealers will replace the side impact air bag module.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 00090)
Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
Risk and remedy
- Risk
- In the event of a vehicle crash, the occupant may not be properly restrained.
- Remedy
- Dealers will inspect the vehicle's safety belt buckle assembly date codes and, if necessary, will replace any safety belt buckle assembly.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 00067)