Owners of the 2000 Chevrolet Blazer have reported 63 brakes problems to NHTSA, 11% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (34), foundation components (17), and antilock (4).
The typical report came at around 79,000 miles, and complaints were filed between May 2000 and October 2020.
These brakes complaints include 9 crashes and 1 injury.
For comparison, the 1995 Blazer has the most brakes complaints of any year, with 531.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Oct 2020122,000 milesNC
When braking the ABS brake system locks. It locks up into a limited slip mode while braking AT a normal stop. It does not brake correctly. It pumps badly while attempting to stop. This happens multiple time a day when driving. Have to break way before needing to because it will slip. Typically happens in parking lots and regular streets when using breaks. In motion. This has been happening since March 2020.
Owner complaint 11366380 filed with NHTSA
BrakesFiled Jun 2020150,000 milesPA
I have replaced the hub assembly, idler arm, & wheel bearings on both driver & passenger side of my vehicle. When I drive over 45 MPH my car makes an awful sound & no matter what I change or have fixed the parking brake/ABS lights stay on. I've had many mechanics look AT & say they've fixed the issue but none have actually fixed it. I was driving 70mph on the highway & my brakes felt as if they were locking up.
Owner complaint 11331221 filed with NHTSA
BrakesFiled Mar 201580,000 milesMO
Tl* the contact owns a 2000 Chevrolet Blazer. The contact stated that the heater and air conditioner failed to function. In addition, the contact stated that the four wheel drive was activated, but failed to engage and the oil pressure gauge displayed an incorrect reading. The ABS warning light illuminated. The vehicle was taken to a dealer. The technician diagnosed that the transfer case needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failures. The failure mileage was 80,000.
Vehicle description: s -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (ABS) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency, and park braking performance."
Risk and remedy
Risk
If this occurred, the seating seal could be broken during vehicle assembly, or from early road inputs or brake fluid cycling, and a leak could occur increasing the brake stopping distance.
Remedy
Dealers will inspect the brake pipe union for signs of brake fluid, and if necessary, install a new brake pipe union.