Owners of the 1991 Chevrolet Blazer have reported 129 brakes problems to NHTSA, 58% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (115), foundation components (13), and antilock (2).
The typical report came at around 79,000 miles, and complaints were filed between January 1995 and September 2003.
These brakes complaints include 27 crashes and 8 injuries.
For comparison, the 1995 Blazer has the most brakes complaints of any year, with 531.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Sep 200379,000 milesMI
While braking and without warning, the ABS failed, which caused the vehicle to experience extended stopping distance. The dealer was notified. *ak consumer: mathew schilling
Owner complaint 10029713 filed with NHTSA
BrakesFiled Aug 2003CA
Consumer was having fuel injection system problems. Fuel was being dumped into the engine. Consumer has taken vehicle to the dealer twice and they could not fix it. When this happened vehicle jerked and black smoke came from the back. Then, vehicle will not run. Also, consumer was experiencing braking problems. Brake pedal sometimes went all the way to the floor before it stopped. This made her feel very uncomfortable.
Owner complaint 10037915 filed with NHTSA
BrakesFiled May 2002CA
Consumer received a recall notice on brake system, however since brakes were serviced, brake light and anti lock system light has illuminated on dashboard. Dealer stated there was nothing wrong with brakes.
Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
Risk and remedy
Risk
If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
Remedy
Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Severe corrosion due to road salt AT the joint of the stamped steel center section and the cast outer section CAN cause the sections to separate.
Risk and remedy
Risk
Separation of the rotor sections CAN cause loss ofbraking ability in the affected wheel. This could result in increased stoppingdistance and/or loss of vehicle control and an accident.
Remedy
Replace the front brake rotors with new rotors with a corrosion protection coating. However, if replacement of brake linings are necessary, it will be done AT owner's expense since brake linings are normal maintenance items.