Owners of the 2002 Chevrolet Silverado have reported 350 brakes problems to NHTSA, 49% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (140), foundation components (77), and antilock (14).
The typical report came at around 50,000 miles, and complaints were filed between January 2002 and February 2016.
These brakes complaints include 39 crashes and 11 injuries.
For comparison, the 1999 Silverado has the most brakes complaints of any year, with 1,003.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Dec 2015165,000 milesPA
About 165,000 miles brake pedal started to pulsate AT low speed when stopping.started out only when I would be turning left,now does it going staight,about 170,000 miles now.had new caliper on driver side,new hub assemblie and sensor on passenger side,brake system flushed,still have problems with brake pedal pulsating,does not matter what kind of road I'm on.
Owner complaint 10809877 filed with NHTSA
BrakesFiled Sep 201590,000 milesME
Tl* the contact owns a 2002 Chevrolet Silverado. While driving AT a low speed, the contact applied the brake pedal and the ABS kicked in; however, there was a loss of brake function. The stopping distance of the vehicle was dramatically reduced. The vehicle was taken to a mechanic who stated that there was a wheel bearing sensor failure. The entire wheel bearing with the sensor was replaced, but the failure recurred multiple times. The contact researched and found NHTSA campaign number: 05v379000. The manufacturer was notified of the issue. The approximate failure mileage was 90,000.
Owner complaint 10776455 filed with NHTSA
BrakesFiled Aug 2015120,000 milesKYCrash
ABS stopped brake pedal from going down. By the time I lifted and pumped again vehicle struck young girl. Travel was about six feet. There is a recall in other states but not ky.
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Risk and remedy
Risk
This CAN cause increased stopping distances during low-speed brake applications, which could result in a crash.
Remedy
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
On certain pickup trucks equipped with manual transmissions and built with either pbr parking brake systems or trw parking brake systems, the parking brake friction linings may wear to an extent where the parking brake CAN become ineffective in immobilizing a parked vehicle.
Risk and remedy
Risk
If the parking brake does not hold, unintended vehicle movement could occur, which could result in a crash.
Remedy
Dealers will install a low-force spring clip retainer for vehicles equipped with a pbr parking brake system. On vehicles equipped with the trw parking brake system, dealers will install a redesigned parking brake cable assembly. The recall began on july 29, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.