Owners of the 1999 Chevrolet Silverado have reported 1,003 brakes problems to NHTSA, 60% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (683), antilock (104), and foundation components (104).
The typical report came at around 63,000 miles, and complaints were filed between January 1999 and December 2015.
These brakes complaints include 56 crashes, 2 fires, and 24 injuries.
No other Silverado year has as many brakes complaints.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
3 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Dec 2015230,000 milesMI
Driving along road, brake pedal went to the floor when I attempted to stop. Upon inspection, discovered that the hydraulic line going from the ABS module to the rear brakes had ruptured due to corrosion. Upon further inspection it has been determined that all of the hydraulic brake lines are swollen and corroded to the point of failure and must be replaced AT a cost of over $1200. My truck has not moved since, as I cannot afford to repair this issue.
Owner complaint 10809995 filed with NHTSA
BrakesFiled Sep 2015170,000 milesFL
While approaching intersection put on brakes and they failed, pedal went to the floor. If I had not been a test driver for chrysler corp. And doing lots of brake and suspension work I could have easily been seriously hurt. The brake lines were shot, rusted through. This vehicle has spent it's life in fl. No salt on the road. I know you have ruled on this being a recall, but I think you made a huge mistake, someone will be killed by this. Thanks
Owner complaint 10761469 filed with NHTSA
BrakesFiled Jul 2015138,000 milesKY
Tl* the contact owns a 1999 Chevrolet Silverado. While driving 20 MPH and attempting to engage the brakes, the accelerator pedal went to the floor and the brakes failed without warning. After inspecting the vehicle, the contact discovered that the brake line was corroded. The vehicle was driven to the contact's residence where he discovered large amounts of brake fluid leaking from various spots on the brake line. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 138,000.
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (ABS) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Risk and remedy
Risk
This CAN cause increased stopping distances during low-speed brake applications, which could result in a crash.
Remedy
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
On certain pickup trucks equipped with manual transmissions and built with either pbr parking brake systems or trw parking brake systems, the parking brake friction linings may wear to an extent where the parking brake CAN become ineffective in immobilizing a parked vehicle.
Risk and remedy
Risk
If the parking brake does not hold, unintended vehicle movement could occur, which could result in a crash.
Remedy
Dealers will install a low-force spring clip retainer for vehicles equipped with a pbr parking brake system. On vehicles equipped with the trw parking brake system, dealers will install a redesigned parking brake cable assembly. The recall began on july 29, 2005. Owners may contact chevrolet AT 1-800-630-2438 or GMC AT 1-866-996-9463.
Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles have a clearance condition between the front right-hand brake pipe and the body cross sill that could decrease to the point of allowing contact during the life of the vehicle. If contact occurs and the brake pipe becomes damaged, in half of the brake system there CAN be a loss of brake fluid and pressure. The brake warning lamp will be activated when the brake fluid level reaches the indicator limit.
Risk and remedy
Risk
During braking, the pedal will be lower than normal and stopping distances will be longer. If this occurs when stopping distance is limited, a crash could occur.
Remedy
Dealers will inspect the front right-hand brake pipe for wear. If there are signs of wear, this section of the brake pipe will be replaced with a new designed brake pipe section. If there are not signs of wear on the brake pipe, the dealer will install a spacer clip to ensure sufficient clearance between the brake pipe and the body cross sill.