Owners of the 2006 Chevrolet Uplander have reported 20 suspension problems to NHTSA, 13% of all complaints about this model year.
Where owners named a specific part, the most common were front (8) and rear (2).
The typical report came at around 28,000 miles, and complaints were filed between September 2006 and June 2019.
These suspension complaints include 1 crash.
No other Uplander year has as many suspension complaints.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints20
Typical mileage28k
Crashes / fires1 / 0
Injuries0
Parts named in these complaints
Front8
Rear2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Jun 201962,000 milesIA
Tl* the contact owns a 2006 Chevrolet Uplander. While driving 20 MPH, the contact heard an abnormal noise coming from the rear of the vehicle. The contact associated the failure with NHTSA campaign number: 10v110000 (suspension). The vehicle was taken to rydell Chevrolet (located AT 1325 e san marnan dr, waterloo, ia 50702, (319) 433-4871) to be diagnosed, but they were unable to duplicate the failure. The vehicle was not repaired. The manufacturer was not notified. The failure mileage was 62,000.
Owner complaint 11220969 filed with NHTSA
SuspensionFiled Sep 201561,000 milesIL
Tl* the contact owns a 2006 Chevrolet Uplander. While driving highway speeds, the contact heard an abnormal noise under the vehicle and noticed a bar hanging under the vehicle. The vehicle was taken to an independent mechanic where it was diagnosed that the lower front body tie bar needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was 61,000.
The braun corporation has notified NHTSA about a defect in certain model year 2005-2008 general motors mobility conversion, handicapped accessible low floor minivans. During conversion, the driver or passenger side trailing arm modification may not have been adequately welded.
Risk and remedy
Risk
A squeaking or clunking noise may develop. The trailing arm bushings may prematurely wear and the trailing arm may fracture or separate, allowing the rear axle to become partially separated from the chassis increasing the risk of a crash.
Remedy
Dealers will inspect and will have a supply of retrofit parts available to remedy the vehicles free of charge. The safety recall began on june 4, 2010. Owners may contact braun AT 1-800-488-0359.