Owners of the 2007 Chevrolet Uplander have reported 7 suspension problems to NHTSA, 6% of all complaints about this model year.
Where owners named a specific part, the most common were rear (2).
The typical report came at around 120,000 miles, and complaints were filed between December 2010 and November 2020.
For comparison, the 2006 Uplander has the most suspension complaints of any year, with 20.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints7
Typical mileage120k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Rear2
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Nov 2020200,000 milesCA
Tl* the contact owns a 2007 Chevrolet Uplander. The contact stated that while reversing into the driveway, the front driver's side rack and pinion fractured making the vehicle inoperable. The vehicle was examined by an independent mechanic who indicated that the cause of the failure was due to a defective material used in the suspension. The local dealer and manufacturer were not notified of the failure. The failure mileage was 200,000.
Owner complaint 11376719 filed with NHTSA
SuspensionFiled Feb 2015150,000 milesFL
2007 chevy Uplander CV axle splines not long enough to fit all the way into hub splines cause shuddering from CV axle wobble. Frequent clicking from changing gear to gear is a result of the CV axle spinning inside the hub (press brake and gas) the remedy for this problem of shuddering and stalling AT when AT a go from a stop is the replace CV axle with one that has a longer shaft with splines that actually extend through the hub so that the hub nut threads do not enter the hub bearing and the CV axle splines run all the way through.
The braun corporation has notified NHTSA about a defect in certain model year 2005-2008 general motors mobility conversion, handicapped accessible low floor minivans. During conversion, the driver or passenger side trailing arm modification may not have been adequately welded.
Risk and remedy
Risk
A squeaking or clunking noise may develop. The trailing arm bushings may prematurely wear and the trailing arm may fracture or separate, allowing the rear axle to become partially separated from the chassis increasing the risk of a crash.
Remedy
Dealers will inspect and will have a supply of retrofit parts available to remedy the vehicles free of charge. The safety recall began on june 4, 2010. Owners may contact braun AT 1-800-488-0359.