Owners of the 1996 Chrysler Sebring have reported 61 brakes problems to NHTSA, 15% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (40), antilock/traction control/electronic limited slip (17), and power assist (3).
The typical report came at around 35,000 miles, and complaints were filed between March 1996 and November 2018.
These brakes complaints include 7 crashes, 2 fires, and 2 injuries.
No other Sebring year has as many brakes complaints.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Sep 2014DECrash
Tl* the contact owns a 1996 Chrysler Sebring. While driving approximately 45 MPH, the vehicle failed to respond when the brake pedal was depressed. The contact crashed the vehicle into a ditch. There were no injuries. The independent mechanic repaired the brake chamber, both rear brake lines, and the adjuster; however, the failure persisted. The manufacturer was not notified of the failure. The failure mileage was unavailable.
Owner complaint 10631677 filed with NHTSA
BrakesFiled Sep 201342,500 milesNJ
Brakes failed and immediately went to the floor when braking somewhat hard while hwy traffic was slowing quickly. If I hadn't pulled the emergency brake quickly, there is no telling what might have happened to my family and I. Brake lines rusted through.
Owner complaint 10544185 filed with NHTSA
BrakesFiled Mar 2010CA
Well when I bought the car the back window was fully out, also when im driving it seems as tho im going slower than what my speedomiter says. The alarm doesnt work AT all. My breaks bont fully break on time so I have to stop earlyer than usual.also one day I was in the car and I put the car in drive and the car started to roll back slowly also the stering wheel locked.also when I put gas in it , it says its half empty fast when I only drive around the corner,but when I turn it off and let it sit for a while the meeter goes up.
The power brake booster vacuum hose was improperly installed on the intake manifold vacuum nipple.
Risk and remedy
Risk
A disconnected vacuum hose causes an increase in engine idle speed and loss of power assist during brake application increasing the risk of a vehicle accident.
Remedy
Dealers will fully install the intake manifold vacuum hose to the vacuum nipple on the intake manifold.