Ford · Bronco

1993 Ford Bronco Recalls

Special purpose vehicle · 4WD/AWD · Regular

There are 5 safety recalls on file for the 1993 Ford Bronco, filed between May 1993 and February 2008. Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1993 Bronco is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

2008 (1)

08V051000 Filed Feb 4, 2008 225,000 vehicles

Cruise control

Ford is recalling 225,000 my 1992-2003 econoline, my 1993-1995 taurus sho, my 1992-1998 crown victoria, my 1993 bronco, f-series, my 1995-1997 f-series super duty stripped chassis, my 1992-1998 mercury grand marquis, and my 1992-1995 lincoln town car vehicles. The affected vehicles were previously repaired using a wiring harness that is not compatible with the vehicle circuit polarity.

Risk and remedy
Risk
As a result, the fuse is located in the output circuit rather than in the intended input power feed circuit, and may not offer the intended protection in the event of an electrical short to ground.
Remedy
Dealers will install a new wiring harness, or replace the mating electrical component. The recall began on february 18, 2008. Owners may contact ford AT 1-800-392-3673.
Filed by
FORD MOTOR COMPANY (manufacturer number 08S01)

2007 (1)

07V336000 Filed Aug 3, 2007 3,600,000 vehicles

Vehicle speed control

On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.

Risk and remedy
Risk
This could result in an underhood fire.
Remedy
Dealers will install a fused wiring harness. Owners of the passenger cars included in this campaign will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected as an interim repair. As soon as repair parts are available (expected october 2007), owners will be instructed to return to the dealers for installation of a fused wiring harness. The recall began on august 13, 2007, and mailing completed by september 19, 2007. Owners may contact ford AT 1-888-222-2751.
Filed by
FORD MOTOR COMPANY (manufacturer number 05S28)

1994 (2)

94V169001 Filed Sep 7, 1994 835,791 vehicles

Conventional

The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.

Risk and remedy
Risk
When the above occurs, it CAN result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
Remedy
A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.
Filed by
FORD MOTOR COMPANY
94V018000 Filed Jan 2, 1994 370,000 vehicles

Bumpers

The u-clip style nuts that retain the front bumpers to the front bumper inner arms CAN fracture.

Risk and remedy
Risk
If one of the u-clip nuts fractures, the bumper will loosen and rattle causing fracture of the remaining u-clip nuts, resulting in separation of the bumper from the vehicle. If the bumper were to detach from the vehicle while it is being driven, a vehicle collision could result.
Remedy
Inspection and replacement of the four u-clip nuts and the associated bolts.
Filed by
FORD MOTOR COMPANY

1993 (1)

93V089000 Filed May 17, 1993 1,389 vehicles

Transfer case (4-wheel drive)

The transfer cases have been built with the wrong electric shift motor. The transfer cases CAN slip out of the 4 x 4 high gear position during coasting in forward gears or with power applied in reverse gear.

Risk and remedy
Risk
If this occurs, the vehicle CAN roll freely as if inneutral position regardless of the transmission gear selector position. This canresult in loss of vehicle control and an accident.
Remedy
Replace defective transfer cases with the correct version.
Filed by
FORD MOTOR COMPANY

Recall questions

How many recalls does the 1993 Ford Bronco have?

NHTSA lists 5 recalls for the 1993 Ford Bronco.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.