Owners have filed 40 complaints about the 1993 Ford Bronco with NHTSA, the 10th highest of 13 Bronco years.
The largest share concerns the brakes (14 complaints, 35% of the total), followed by transmission and drivetrain (8) and tires (6). Half of those brakes reports describe a failure before 122,000 miles.
Complaints for this year mention 4 crashes, 2 fires, and 2 injuries. These are owner reports and have not been verified by NHTSA.
NHTSA lists 5 recalls for this model year. The most recent, campaign 08V051000, was filed in February 2008 and concerns the cruise control.
EPA figures put it at up to 14 MPG combined (12 city, 17 highway) in its most efficient version, out of 3 configurations tested, 3 MPG worse than the average special purpose vehicle of 1993.
Ford is recalling 225,000 my 1992-2003 econoline, my 1993-1995 taurus sho, my 1992-1998 crown victoria, my 1993 bronco, f-series, my 1995-1997 f-series super duty stripped chassis, my 1992-1998 mercury grand marquis, and my 1992-1995 lincoln town car vehicles. The affected vehicles were previously repaired using a wiring harness that is not compatible with the vehicle circuit polarity.
Risk and remedy
- Risk
- As a result, the fuse is located in the output circuit rather than in the intended input power feed circuit, and may not offer the intended protection in the event of an electrical short to ground.
- Remedy
- Dealers will install a new wiring harness, or replace the mating electrical component. The recall began on february 18, 2008. Owners may contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 08S01)
07V336000
Filed Aug 3, 2007 3,600,000 vehicles
On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.
Risk and remedy
- Risk
- This could result in an underhood fire.
- Remedy
- Dealers will install a fused wiring harness. Owners of the passenger cars included in this campaign will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected as an interim repair. As soon as repair parts are available (expected october 2007), owners will be instructed to return to the dealers for installation of a fused wiring harness. The recall began on august 13, 2007, and mailing completed by september 19, 2007. Owners may contact ford AT 1-888-222-2751.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 05S28)
The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
Risk and remedy
- Risk
- When the above occurs, it CAN result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
- Remedy
- A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.
- Filed by
- FORD MOTOR COMPANY