Owners of the 1994 Ford Bronco have reported 42 brakes problems to NHTSA, 46% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (25), antilock/traction control/electronic limited slip (19), and conventional (1).
The typical report came at around 130,000 miles, and complaints were filed between January 1995 and February 2015.
These brakes complaints include 2 crashes and 1 fire.
No other Bronco year has as many brakes complaints.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Apr 2013175,000 milesMD
The 1994 Ford Bronco equipped with speed control had Ford recall no. 05s28 accomplished in 2008. In 2012 the wiring overheated and caused damage and a leak to the master cylinder reservoir and had to be disconnected. When Ford was contacted they instructed that the recall had been accomplished and they could not warranty the part.
Owner complaint 10509521 filed with NHTSA
BrakesFiled Feb 2009105,000 milesSC
Tl*the contact owns a 1994 Ford Bronco. The contact stated that the parking brake does not hold. On several occasions, he applied the parking brake and the vehicle rolled in the direction of the hill on where it was parked. The dealer stated that NHTSA campaign ID number 94v169001 (parking brake:conventional) was not an active recall. The manufacturer stated that the recall was not in their database and refused to perform the repair. The current mileage was 180,781 and failure mileage was approximately 105,000. Updated 03/09/09. *lj updated 03/11/09.
Owner complaint 10258054 filed with NHTSA
BrakesFiled Dec 2003144,000 milesSC
Parking brake slipped when applied, causing the vehicle to roll freely. This vehicle was manufactured on March 1994. Dealer and manufacturer stated we didn't care when it was manufactured in 1994, there was not recall on this vehicle.
The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
Risk and remedy
Risk
When the above occurs, it CAN result in parking brake system ineffectiveness. The parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
Remedy
A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. Also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.