Owners of the 1992 Ford Crown Victoria have reported 16 seat problems to NHTSA, 5% of all complaints about this model year.
Where owners named a specific part, the most common were front assembly (6).
The typical report came at around 84,000 miles, and complaints were filed between February 1995 and May 2004.
These seat complaints include 1 fire.
No other Crown Victoria year has as many seat complaints.
Seat frames, recliners, tracks, heated seats and head restraints.
1 recall for this model year involves the seat.
If your problem matches, a dealer repairs it free under the recall.
Complaints16
Typical mileage84k
Crashes / fires0 / 1
Injuries0
Parts named in these complaints
Front Assembly6
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SeatsFiled May 200484,000 milesMA
(1.) my car is a 1992 Ford, Crown Victoria LX. - I got into the vehicle and leaned back on the back of the seat to get something out out of my pants pocket. As I pressed on the back of the seat there was a metalic "snap" sound and the back of the seat flopped back 3 to 4 inches on the driver door side. Later on viewing the seat from the front of the car in front of the brake peddle I was able to determing that a welded in circular, threaded, metal, tapped fastener, (a custom made nut) had torn through the pressed metal fram that attached it to the motorized portion of the seat.
Owner complaint 10072818 filed with NHTSA
SeatsFiled Dec 2000NJ
Front left seat to track attachment bolt tore away when someone leaned on the seats' backrest to reach for something behind the seat. The seat is no longer anchored AT that front left corner leaving an unsafe condition. In a rearend collision the seat CAN easily tilt back causing injury to passengers.
An unused power seat harness connector is positioned on the rubber floor mat under the seat. If the vehicle is operated in cold weather in areas that have large amounts of salt used for snow and ICE control, a puddle of saltwater CAN accumulate on the rubber floor mats, repeatedly wetting the connector. This will result in corrosion of the connector, causing a current to flow between the terminals without tripping the circuit breaker.
Risk and remedy
Risk
If this occurs, current flow CAN heat the connector andrelease fumes into the passenger compartment, and CAN result in a vehicle fire.
Remedy
Dealers will remove the unused connector and install a sealed heat shrink cap over the affected wires.