There are 14 safety recalls on file for the 1999 Ford F-250,
filed between May 1998 and July 2011.
Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1999 F-250 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2011 (1)
11V385000
Filed Jul 29, 2011 1,100,000 vehicles
Ford is recalling certain 1997 through 2003 model year ford F-150, 2004 model year ford F-150 heritage, 1997 through 1999 model year F-250 less than 8,500 lbs. Gross vehicle weight rating (gvwr), and 2002 and 2003 lincoln blackwood vehicles manufactured from june 20, 1995, through august 4, 2004, originally sold, or currently registered in, connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia. Prolonged exposure to road deicing chemicals may cause severe corrosion of the fuel tank straps which secure the tank to the vehicle.
Risk and remedy
- Risk
- As a result of the corrosion, one or both straps may fail allowing the fuel lines to separate from the tank, or in some cases, causing the tank to contact the ground. Either scenario may result in a fuel leak presenting a fire hazard.
- Remedy
- Ford will notify owners and instruct them to take their vehicles to a ford or lincoln dealer to have the fuel tank straps replaced with straps that have increased corrosion protection. Early in this campaign, if replacement straps are not available, dealers may install a cable support under the strap as an interim repair or a steel reinforcement over the existing strap as a permanent repair. Any repairs will be performed free of charge. The safety recall began on september 16, 2011. Owners may contact ford motor company customer relationship center AT 1-866-436-7332. Ford's recall campaign number is 11s21
- Filed by
- FORD MOTOR COMPANY (manufacturer number 11S21)
2006 (1)
06V286000
Filed Aug 1, 2006 1,200,000 vehicles
On certain trucks equipped with speed control, gasoline or natural gas engines, the speed control deactivation switch may overheat.
Risk and remedy
- Risk
- Overheating could result in smoke or burn and an underhood fire.
- Remedy
- Dealers will install a fused wiring harness into the speed control system free of charge. The recall began on august 7, 2006. Owners may contact ford AT 1-866-436-7332. (note: also see recalls 05v017 and 05v388)
- Filed by
- FORD MOTOR COMPANY (manufacturer number 05S28)
2005 (1)
05V388000
Filed Sep 7, 2005 4,500,000 vehicles
On certain pickup trucks and sport utility vehicles equipped with speed control, the speed control deactivation switch may overheat, smoke, or burn.
Risk and remedy
- Risk
- A fire AT the switch could occur.
- Remedy
- By letter dated september 12, 2005, owners were instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. Owners who have had their speed control deactivated are being notified that parts will be available and advised to make an appointment to reconnect the speed control beginning in february 2006. Owners who did not have their speed control deactivated are being notified to have their system remedied beginning in february 2006. Owners are urged to avail themselves of the free disconnect service as soon as possible because of the significant risk of fire. Owners may contact ford AT 1-800-392-3673. (note: also see recalls 05v017 and 06v286)
- Filed by
- FORD MOTOR COMPANY (manufacturer number 05S28)
2002 (1)
On certain pickup trucks equipped with manual transmissions, failure of the front parking brake cable input button could result in failure of the parking brake system to hold the vehicle stationary.
Risk and remedy
- Risk
- This could result in unintended vehicle movement and a vehicle crash.
- Remedy
- Dealers will replace the front parking brake cable and the controller and verify the performance of the parking brake system. Owner notification began april 5, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-866-436-7332.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 02S34)
2000 (1)
Vehicle description: bi-fuel cng pickup trucks and bi-fuel cng vans, modified by cfi control systems, inc., fail to conform to the requirements of fmvss no. 303, "fuel system integrity of compressed natural gas vehicles." the label affixed to the fuel filler door by the vehicle modifier contains the inspection date and expiration date of the cng tank. However, it does not contain the statement "see instructions on the fuel container for inspection and service life."
Risk and remedy
- Risk
- These vehicles do not comply with the requirements.
- Remedy
- Owners will be provided a label with the required statement, along with instructions for affixing the label AT the fuel filler door. Owner notification began november 2, 2000. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00L07)
1999 (5)
Vehicle description: pickup trucks equipped with gasoline engines and 8 foot boxes, may not fully satisfy the requirements of fmvss no. 301, "fuel system integrity." in a 30 MPH frontal barrier crash test, a fuel tank vapor recovery valve separated internally. During the subsequent static rollover test, fuel spillage exceeded the specified rate.
Risk and remedy
- Risk
- Fuel leakage, in the presence of an ignition source, could result in a fire.
- Remedy
- Dealers will install a stop plate assembly on the vehicle frame to prevent recovery valve contact with a frame crossmember during the impact sequence.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 99S32)
99V219000
Filed Aug 12, 1999 245,300 vehicles
Vehicle description: gasoline and diesel engine pickup trucks equipped with 8 foot beds, do not fully satisfy the requirements of fmvss no. 301, "fuel system integrity." the fuel tank front strap isolator may not be properly positioned which could result in the strap cutting the tank during a 30 MPH front barrier test, resulting in fuel spillage.
Risk and remedy
- Risk
- During the subsequent static rollover test, fuel spillage exceeded the specified rate, increasing the risk of a fire.
- Remedy
- Dealers will reposition the front strap isolator.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 99S11)
99V093002
Filed Apr 27, 1999 102,700 vehicles
Vehicle description: pickup trucks equipped with 6" beds manufactured from january 5, 1998 through june 4, 1999, do not not fully satisfy the post crash test static rollover requirements of fmvss no. 301, "fuel system integrity." contact between the fuel tank and a fuel tank locator bracket during a front barrier impact test resulted in a cut in the tank, resulting in fuel leakage.
Risk and remedy
- Risk
- Fuel leakage in the presence of an ignition source could result in a fire.
- Remedy
- Dealers will replace the fuel tank locator bracket with a similar bracket whose design has been revised to incorporate more rounded surfaces where contact with the tank occurs.
- Filed by
- FORD MOTOR COMPANY
99V093001
Filed Apr 27, 1999 293,650 vehicles
Vehicle description: gasoline and diesel engine pickup trucks equipped with 6" and 8" beds manufactured from january 5, 1998 through march 21, 1999, do not not fully satisfy the post crash test static rollover requirements of fmvss no. 301, "fuel system integrity." six attachment bolts (m12 bolts) may have been damaged during the 30 MPH front barrier test allowing the bolts to shift or become detached, resulting in fuel spillage.
Risk and remedy
- Risk
- Fuel leakage in the presence of an ignition source could result in a fire.
- Remedy
- Dealers will augment the box-to-chassis attachment by installing box-to-chassis retaining cables.
- Filed by
- FORD MOTOR COMPANY
99V062001
Filed Mar 30, 1999 898,739 vehicles
Vehicle description: certain 1997-1999 rhd explorer equipped with 4.0l ohv/sohc engines and cruise control built from may 29, 1996 through march 4, 1999; 1998-1999 explorer/mountaineers equipped with 4.0l ohv/sohc or 5.0l engines or 1998-1999 rangers equipped with 2.5l, 3.0l ffv/efi or 4.0l engines and cruise control built from january 5, 1998 through march 4, 1999; 1998-1999 mustangs equipped with 3.8l, 4.6l 2-valve or 4-valve engines and cruise control built from march 2, 1998 through march 4, 1999; 1999 f250/f350/f450/f550 (over 8,500 lbs.) trucks equipped with 5.4l or 6.8l engines and cruise control built from march 2, 1998 through march 4, 1999; and 1999 f-53 stripped chassis equipped with 5.4l or 6.8l engines and cruise control built from march 2, 1998 through march 4, 1999. A cruise control cable CAN interfere with the speed control servo pulley and not allow the throttle to return to idle when disengaging the cruise control.
Risk and remedy
- Risk
- If the cruise control is used and this condition is present, a stuck throttle could result, which could potentially result in a crash.
- Remedy
- Dealers will replace the cruise control cables. AT the present time, the replacement cables are not available. Customers are being advised not to use the cruise control system until a replacement CAN be made.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 99S09)
1998 (4)
Vehicle description: light duty trucks. The cast tow hooks changes the crash pulse of the vehicle in frontal barrier impacts and the air bag sensor was not calibrated to this new crash pulse which may cause the air bags to deploy in lower speed impacts than design intent.
Risk and remedy
- Risk
- Unexpected air bag deployment CAN result in personal injury.
- Remedy
- Dealers will replace the cast tow hooks with forged hooks.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 98S34)
Vehicle description: light duty pickup trucks. A speed control cable may not have fully seated into the accelerator bracket AT time of installation. If the cable is not fully seated into this bracket, the cable could separate from the bracket.
Risk and remedy
- Risk
- A loose cable CAN result in the throttle not fully returning to idle and cause an increase in stopping distance.
- Remedy
- Dealers will add a retaining clip to the speed control cable fitting AT the accelerator bracket.
- Filed by
- FORD MOTOR COMPANY
Vehicle description: light duty pickup trucks. The fuel pressure regulator o-ring may have been damaged when the fuel pressure regulator was installed in the engine fuel rail. If the o-ring is damaged, fuel vapor or leakage could occur.
Risk and remedy
- Risk
- If an ignition source is present, a fire could result.
- Remedy
- Dealers will replace the fuel pressure regulator.
- Filed by
- FORD MOTOR COMPANY
Vehicle description: medium duty trucks and chassis-cabs. One or more of the four rivets on the lower steering shaft flex coupling may not have been crimped during the sub-assembly process.
Risk and remedy
- Risk
- If a rivet is not crimped, the flex joint CAN rotate on the shaft and there would be a reduction in or loss of steering control.
- Remedy
- Dealers will inspect the lower steering shaft rivets and replace any shafts with uncrimped rivets.
- Filed by
- FORD MOTOR COMPANY
Recall questions
How many recalls does the 1999 Ford F-250 have?
NHTSA lists 14 recalls for the 1999 Ford F-250.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.