Owners of the 2000 Ford Focus have reported 31 seat problems to NHTSA, 1% of all complaints about this model year.
Where owners named a specific part, the most common were front assembly (19) and mid/rear assembly (3).
The typical report came at around 51,000 miles, and complaints were filed between June 2000 and April 2014.
These seat complaints include 2 crashes and 3 injuries.
No other Focus year has as many seat complaints.
Seat frames, recliners, tracks, heated seats and head restraints.
1 recall for this model year involves the seat.
If your problem matches, a dealer repairs it free under the recall.
Complaints31
Typical mileage51k
Crashes / fires2 / 0
Injuries3
Parts named in these complaints
Front Assembly19
Mid/Rear Assembly3
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SeatsFiled Apr 201447,000 milesIL
A hole appeared in the driver's seat upholstery, near the drivers left hip. Disassembly of the seat cushion revealed a broken weld which allowed a sharp metal piece to puncture the upholstery. I also observed this on replacement seats I purchased from a 2002 svt Focus. Photos (of the 2000 seat) AT https://flic.kr/p/mle2fp; https://flic.kr/p/mlduyh; https://flic.kr/p/mle5w6. I was aware of the hole when I purchased this car in 2005, but did not discover the cause until recently, when the seat folding mechanism failed, and I had to replace the seats, and noticed a similar hole in several that I saw.
Owner complaint 10577877 filed with NHTSA
SeatsFiled Aug 2007SC
Re: NHTSA campaign: 00v-418 - - in July 2007 we bought a 2000 Ford Focus wagon as a 2nd car. Upon lowering the back seat to load items, the seat separated from the hinge. Researching this problem on the internet I learned of the above NHTSA recall campaign and contacted Ford. They state that no recall was issued for my vehicle and refuse any further comment, even though the defect in my car is exactly as described in the recall notice. I even referred their "customer relations" office to your website as an "fyi" but they adamantly refuse to reply with any meaningful response.
Owner complaint 10198506 filed with NHTSA
SeatsFiled Jan 2006275 milesVT
Dt: the consumer stated there were multiple problems with the vehicle. The brakes make noises and pulsated when the pedal was depressed. The vehicle was taken to the service dealer where the brake light switch and ignition cylinder switches were replaced. The dealer also turned the drums, replaced the brake pads and resurfaced the front rotors. There was a vibration in the front end when braking. The lower ball joint, right wheel bearings, right front sway bar link, bone socket, steering rack column and tie rod ends were replaced in an attempt to remedy the problem. The tail light covers retained moisture and condensation built up.
Vehicle description: station wagons and 3-door vehicles. The subject vehicles have a folding 60/40 second seat that becomes a load floor in the folded position. When the 60% portion of the seat is folded down and a load is applied to the front edge of the load floor, the outboard hinge pivot could disengage from the hinge.
Risk and remedy
Risk
If the seat is then returned to the upright position without re-engaging the hinge pivot, the seat and seat belts may not provide the intended level of performance in the event of a crash.
Remedy
Dealers will install a revised seat back hinge pivot.