There are 11 safety recalls on file for the 2000 Ford Focus,
filed between December 1999 and February 2005.
Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 2000 Focus is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
2005 (1)
Certain passenger vehicles with four or five doors and originally sold in or currently registered in connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, a build-up of corrosion AT the pawl pivot area of the rear door latch CAN cause a binding condition of the pawl that may affect proper engagement of the pawl into the catch. The occupant may experience difficulty opening or closing a rear door, and eventually the rear door may not latch properly.
Risk and remedy
- Risk
- If not latched properly, the door may open while the vehicle is in motion. If an occupant fell out of the vehicle, personal injuries could occur.
- Remedy
- Dealers will have a lower rocker seal added to the door and have the rear door latches evaluated free of charge. A latch that passes the evaluation will be lubricated to prevent future corrosion. A latch that does not pass the evaluation will be replaced. In addition, a sticker will be affixed to the rear doors advising the owners to use the recommended lubricant. The recall began on march 9, 2005. Owners may contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 05S27)
2003 (1)
03V482000
Filed Nov 19, 2003 671,000 vehicles
On certain passenger vehicles, contamination of the filter in the fuel delivery module (fdm) CAN reduce, and eventually block, the flow of fuel to the engine.
Risk and remedy
- Risk
- This may cause engine hesitation, loss of power, surging, and other similar symptoms. Over time, the filter may become sufficiently blocked to cause the engine to stall, which could result in a crash.
- Remedy
- This action is deemed a safety improvement campaign and is not being conducted under the safety act. All owners will be notified of the problem, and dealers will replace the fdm with a new design AT no charge if the owner reports that the vehicle exhibits any of the identified symptoms. The free replacement will be available for a period of 10 years following the original purchase of the vehicle, with no mileage limit. Owner notification is expected to begin during november 2003. Owners should contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 03N01)
2002 (2)
Certain passenger vehicles have loose pinch bolts that secure the lower control arm to the steering knuckle have been reported.
Risk and remedy
- Risk
- Loose pinch bolts could exhibit noise, vibration and, in extreme cases if left uncorrected, separation of the joint or fracture of the ball joint stud, increasing the risk of a crash.
- Remedy
- Dealers will inspect the steering knuckle pinch bolt for tightness and correct as necessary. Owner notification began february 10, 2003. Owners who do not receive the free remedy within a reasonable time should contact ford AT 1-866-436-7332.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 02S42)
Certain passenger vehicles equipped with zetec engines, loose or broken attachments and misrouted battery cables could lead to cable insulation damage.
Risk and remedy
- Risk
- This, in turn, could cause the battery cables to short resulting in heat damage to the cables. Besides heat damage, the "check engine" light may illuminate, the vehicle may fail to start, or smoke, melting, or fire could also occur.
- Remedy
- Dealers will inspect the battery cables for the condition of the cable insulation and proper tightening of the terminal ends. As necessary, cables will be rerouted, retaining clips installed, and damaged battery cables replaced. Owner notification began february 10, 2003. Owners who do not receive the free remedy within a reasonable time should contact ford AT 1-866-436-7332.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 02S41)
2001 (1)
01V258000
Filed Aug 8, 2001 1,083,000 vehicles
Vehicle description: passenger cars, sport utility vehicles, and light and medium duty pickup trucks. A switch located in the plastic cover of the wiper motor gear case could malfunction and overheat, potentially resulting in loss of intermittent wiper function, loss of wiper park function, complete loss of wiper function, or ignition of the plastic cover material. Switch malfunction is most likely to occur when the intermittent setting of the wipers is being used, or when snow or ICE obstructs the blades from returning to the "parked" position AT the bottom of the windshield. These vehicles were built AT the following assembly plants: atlanta plant from 2/11/00 through 7/31/00; chicago plant from 2/14/00 through 8/4/00; kansas city plant from 2/26/00 to 9/4/00; kentucky truck plant from 2/18/00 to 8/31/00; michigan truck plant from 2/23/00 through 8/3/00; norfolk plant from 2/21/00 through 7/27/00; wayne stamping and assembly plant from 2/25/00 through 8/15/00; and wixom plant from 2/15/00 through 8/8/00.
Risk and remedy
- Risk
- Loss of visibility while driving increases the risk of a crash.
- Remedy
- Dealers will inspect the date code on the wiper motor. Motors built with the suspect time frame will have the wiper motor gear case cover replaced. Owner notification began august 20, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-866-436-7332.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 01S24)
2000 (5)
Vehicle description: station wagons and 3-door vehicles. The subject vehicles have a folding 60/40 second seat that becomes a load floor in the folded position. When the 60% portion of the seat is folded down and a load is applied to the front edge of the load floor, the outboard hinge pivot could disengage from the hinge.
Risk and remedy
- Risk
- If the seat is then returned to the upright position without re-engaging the hinge pivot, the seat and seat belts may not provide the intended level of performance in the event of a crash.
- Remedy
- Dealers will install a revised seat back hinge pivot.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S55)
Vehicle description: passenger vehicles. A decklid wire harness CAN fatigue and develop broken wires in the bend area of the wire harness.
Risk and remedy
- Risk
- This could result in either a loss of individual lamp functions, or in the case of a short of the broken wires that causes a fuse to open, in the loss of stop lamp or tail lamp function. Loss of stop lamp or tail lamp function could increase the risk of a crash.
- Remedy
- Dealers will replace the decklid wire harness.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S50)
00V303000
Filed Oct 12, 2000 203,700 vehicles
Vehicle description: passenger vehicles. The rear wheel hub retaining nuts CAN loosen and allow the left rear wheel and brake drum assembly to separate from the vehicle.
Risk and remedy
- Risk
- This condition could result in a vehicle crash.
- Remedy
- Dealers will inspect the rear wheel bearings and install a rear wheel retention cap to prevent left rear wheel separation. Owner notification began october 12, 2000. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S31)
Vehicle description: passenger vehicles equipped with speed control and automatic transmission. A speed control cable could have a core wire that is long enough to catch on the sleeve AT the throttle body end of the cable during wide-open throttle acceleration.
Risk and remedy
- Risk
- A throttle that does not return to idle could result in reduced vehicle control and, potentially, a vehicle crash.
- Remedy
- Dealers will inspect these vehicles and, if necessary, replace the speed control cable. Owner notification began october 12, 2000. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford AT 1-800-392-3673.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S30)
00V218000
Filed Aug 11, 2000 276,500 vehicles
Vehicle description: passenger vehicles. Certain vehicles fail to comply with requirements of fmvss no. 201, "occupant protection in interior impact." the resultant hic(d) value AT one target location ap1, located on the trim panel AT the juncture of the a-pillar and roof side rail, may be greater than design intent.
Risk and remedy
- Risk
- In the event of a crash, an occupant contacting that location may not be provided the interior impact protection intended.
- Remedy
- Dealers will remove the left and right side b-pillar and a-pillar trim panels, revise the headliner edge near the tops of the a-pillars to accept the new a-pillar trim panels with their energy absorbing tubes, and install the new a-pillar and the old b-pillar trim panels.
- Filed by
- FORD MOTOR COMPANY (manufacturer number 00S20)
1999 (1)
Vehicle description: passenger vehicles equipped with speed control. The speed control cable end fitting CAN allow water to enter the speed control servo assembly. If this occurs, corrosion in the servo assembly could develop and cause intermittent speed control operation or prevent the throttle from returning to idle.
Risk and remedy
- Risk
- A throttle that does not return to idle could result in unexpected acceleration, increasing the risk of a crash.
- Remedy
- Dealers will replace the speed control cable (with a new cable that incorporates a glass-filled end cap) and inspect the assembly for internal corrosion. Servos with evidence of corrosion will also be replaced. Owners are advised not to use the speed control until the vehicles are repaired.
- Filed by
- FORD MOTOR COMPANY
Recall questions
How many recalls does the 2000 Ford Focus have?
NHTSA lists 11 recalls for the 2000 Ford Focus.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.